Check
Point of
Hours
Lubrication
Engine crankcase
Check
before
each
use
Hydro transmis-
Check
sion and transaxle
before
with filter.
each
use
Steering knuckles
10
and front axle
pivot bolt
Front wheel
30
bearings
Steering gear
30
housing
Foot and lift con-
10
trol pivot points
LUBRICATION TABLE
Change
at
at
Capacity
Hours
100
Approx.
4 pints
Add as
Approx.
needed
6 qts.
Anticipated Air Temperature
Above + 32°F
Cub Cadet
Engine Oil SAE
10W30 or 10W40
Cub Cadet Drive System Fluid Plus
NOTE: Cub Cadet Drive System Fluid Plus is specially
formulated for this application. If any other oil is used
Cub Cadet will not be responsible for substandard
perormance. Failures due to use of improper fluid are
not covered by warranty. For maximum protection, use
Cub Cadet Drive System Fluid Plus.
Use 251H EP grease or equivalent No. 2 multi-
purpose lithium grease and apply two strokes
(minimum) or sufficient grease to flush out old
grease and dirt.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Use a liberal amount of high grade lubricating oil.
39
Below + 32°F
Cub Cadet
Engine Oil SAE
5W20 or 5W30