Table of Contents
Advertisement
TG8011E(e).book Page 41 Tuesday, June 23, 2009 8:50 AM
Battery recharge
Problem
The handset beeps and/or 3
flashes.
I fully charged the batteries, but
3 still flashes.
I fully charged the batteries, but
the operating time seems to be
shorter.
Making/answering calls, intercom
Problem
w is flashing.
Noise is heard, sound cuts in
and out.
The handset does not ring.
I cannot make a call.
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Useful Information
Cause/solution
L Battery charge is low. Fully charge the
batteries (page 13).
L Clean the charge contacts and charge again
(page 14).
L It is time to replace the batteries (page 13).
L Clean the battery ends (S, T) and the
charge contacts with a dry cloth, and charge
again.
Cause/solution
L The handset is not registered to the base unit.
Register it (page 28).
L The handset is too far from the base unit.
Move closer.
L The base unit's AC adaptor is not connected.
Check the connections.
L You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L You are using the handset or base unit in an
area with high electrical interference. Re-
position the base unit and use the handset
away from sources of interference.
L Move closer to the base unit.
L If you use a DSL/ADSL service, we
recommend connecting a DSL/ADSL filter
between the base unit and the telephone line
jack. Contact your DSL/ADSL provider for
details.
L The ringer volume is turned off. Adjust ringer
volume (page 23).
L Night mode is turned on. Turn it off
(page 27).
L The handset is too far from the base unit.
Move closer and try again.
L Another unit is in use. Wait and try again later.
L The key lock feature is turned on. Turn it off
(page 19).
41
Advertisement
Table of Contents
