Replacing The Surface Light - GE ADVANTIUM PSA9240 Owner's Manual

Replacing the
surface light
Removing
and cleaning
the filters
Replacing the
oven cavity
lamp
1. To replace the surface light, first
disconnect the power at the main
fuse or circuit breaker panel.
2. Remove the screw from the side of
the light compartment cover and
lower the cover until it stops.
3. Be sure the bulb to be replaced is
cool before removing. Gently pull the
bulb from the receptacle.
Replace with a 130 volt, 50-watt halogen
bulb. Order WB08X10051 from your
GE Appliances supplier.
4. Raise the light cover and replace the
screw. Connect electrical power to
the oven.
1. The metal filters trap grease released
by foods on the cooktop. They also
prevent flames from foods on the
cooktop from damaging the inside of
the oven.
2. For this reason, the filters must
always be in place when the hood
is used. The vent filters should be
cleaned once a month, or as needed.
3. To remove, slide them to the rear
using the tabs. Pull down and out.
4. To clean the vent filters, soak them
and then swish around in hot water
and detergent. Don't use ammonia
or ammonia products because they
will darken the metal. Light brushing
can be used to remove embedded
dirt.
1. Disconnect power at the main fuse or
circuit breaker panel.
2. Remove the top grill by removing the
two screws that hold it in place.
3. Remove charcoal filter if present.
Slide the filter toward the left and pull
toward the front to remove. Note:
Charcoal filter is an optional kit, you
may not have one.
4. Remove the screw holding the lamp
shield in place.
Care and Cleaning
Advantium Oven
Remove screw
5. Rinse, shake and let dry before
replacing.
6. To replace, slide the filters into the
frame slots on the back of each
opening. Press up and to the front to
lock into place.
5. Pull the lamp shield out. Pull the
light bulb out and replace with the
120V-130V, 20W halogen bulb.
Order WB25X10019 from your GE
Appliances supplier.
6. Return the lamp and lamp shield to
original position and replace screw
and charcoal filter.
7. Replace the grill and 2 screws.
Reconnect power to the oven.
35