Table of Contents
Advertisement
6. If some noise or distortion is still visible select Phase using the
buttons.
7. With the Clock set to the optimal value adjust the Phase to further optimise
the displayed image. You should now be able, with a combination of the
Focus and Clock settings, to obtain a perfectly stable image.
8. Finalise the manual adjustment using the H. Position and V. Position
functions, located in the Image Position category.
If you are still not satisfied with the result, try repeating the above procedure
using a graphics signal that has a different refresh rate.
Please Note:
You must use one of the factory modes when manually adjusting the picture. If
you are having difficulties generating a supported mode, ask your computer
dealer or the distributor or manufacturer of your graphics card for assistance.
The procedures described in this chapter should be performed for every
resolution and type of graphics signal that you wish to use. For example, if a
particular application requires a resolution of 800 x 600 pixels, but all other
applications use the monitor's native resolution, you will need to display the
test pattern and make adjustments twice.
The monitor will remember your settings and use them whenever you turn the
monitor on. Note that you may need to re-adjust the monitor if it is connected to
a different computer or if the computer's graphics adaptor is replaced.
17
17
or
Advertisement
Table of Contents
