Connecting The Am (Mw)/Lw Aerial; Connecting The Fm Aerial - Samsung MM-ZJ8DAB Instruction Manual

Connecting the AM (MW)/LW Aerial

The AM aerial (for long and medium waves) can be:
Placed on a stable surface
Fixed to the wall (you must first remove the base)
The AM aerial connector terminals are located on the rear of the system and are marked AM ANT.
To avoid noise interference, check that the loudspeaker wires do not run close to the
aerial wires.
Always keep them at least 2 inches (5 cm) away.

Connecting the FM Aerial

How to connect a COAXIAL TYPE aerial.
Connect a 75Ω antenna to the FM antenna terminal.
Plug the connector on the FM aerial supplied into the coaxial socket (75Ω) marked FM on the rear of the system.
Follow the instructions given on Page 15 to tune into a radio station, and determine the best position for the aerial.
If reception is poor, you may need to install an outdoor aerial.
To do so, connect an outdoor FM aerial to the FM socket on the rear of the system using a 75Ω coaxial cable (not supplied).
Connecting the DAB Antenna (Inclded)
1
Connect the connector on the end of the DAB antenna cable into the DAB antenna input on the back of the unit.
2
Attach the end of the DAB antenna cable to a wall with good reception.
GB
9