Selecting The Input Signal - Panasonic TH-103PF12W Operating Instructions Manual

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Input terminal will not be selected if the terminal board is not installed
into the SLOT.
• Select to match the signals from the source connected to the
component/RGB input terminals. (see page 50)
• In 2 screen display, the same input mode cannot be selected for the
main picture and sub picture.
• Image retention (image lag) may occur on the plasma display panel
when a still picture is kept on the panel for an extended period. The
function that darkens the screen slightly is activated to prevent image
retention (see page 63), but this function is not the perfect solution to
image retention.
16
Press to select the input signal to be played back from the
equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2A
SLOT2 is for dual input so that you can select INPUT2A or
INPUT2B for INPUT2.
INPUT2A : HDMI signal terminal in SLOT2
INPUT2B : HDMI signal terminal in SLOT2
Press the INPUT "1", "2", "3" or "PC" input mode selection button
to select the INPUT mode.
Press to switch the input mode between INPUT2A and
INPUT2B.
INPUT2B INPUT3 PC
ENTER/
+
/
VOL
-
/
MENU
INPUT