Lamp/Maintenance Indicators - Sharp XG-V10XE Operation Manual

Lamp/Maintenance Indicators

Maintenance Indicators
TEMP LAMP2
2
TEMPERATURE LAMP 2
WARNING REPLACEMENT
indicator indicator
Maintenance Indicator
TEMPERATURE The internal
WARNING indicator temperature is
abnormally high.
The lamp does not
LAMP REPLACE-
light up.
MENT indicator
The lamp requires
replacement.
POWER indicator
The POWER
indicator flashes in
red when the
projector is on.
* The lens cover is as shown below.
• If the TEMPERATURE WARNING indicator lights up, follow the above possible solutions and then wait until the projector has
cooled down completely before turning the power back on. (At least 5 minutes.)
• If the power is turned off and then turned on again, as during a brief rest, the LAMP REPLACEMENT indicators may be
triggered, preventing the power from going on. Should this occur, take the power cord out of the wall outlet and put it back
in again.
69
LAMP1 POWER
1
LAMP 1 POWER
REPLACEMENT indicator
indicator
Condition
• Blocked air intake.
• Clogged air filter.
• Cooling fan breakdown.
• Internal circuit failure.
• Burnt-out lamp.
• Lamp circuit failure.
• Lamp has been used for
over 900 hours.
• The filter cover is open.
• The lens cover* is not
securely installed.
Lens cover
• The warning lights on the projector indicate problems
inside the projector.
• There are three warning lights: a TEMPERATURE
WARNING indicator that warns you when the projector
is too hot, and two LAMP REPLACEMENT indicators
that warn you when to change a lamp.
• If a problem occurs, either the TEMPERATURE
WARNING indicator or the LAMP REPLACEMENT
indicators will light up red. After turning off the power,
follow the procedures given below.
Problem
• Relocate the projector to an area with
proper ventilation.
• Replace the filter.
(See page 73.)
• Take the projector to your nearest Sharp
Authorised LCD Projector Dealer or Service
Centre for repair.
• Carefully replace the lamp. (See pages 71
and 72.)
• Take the projector to your nearest Sharp
Authorised LCD Projector Dealer or Service
Centre for repair.
• Securely install the filter cover.
• Securely install the lens cover.
Possible Solution