Radio functions
GB
IE
Select frequency range
Automatic station search
Manual station selection
Storing radio stations
Searching for stations with alternative frequencies
Selecting stored stations
20
♦
Press the BD/ENT button
medium wave (M 1, M 2).
♦
Press ▸▸I
or I◂◂
2
The search stops when a station is found.
Hold down either ▸▸I or I◂◂ for two seconds, MANUAL appears on the
♦
display
.
6
♦
Now press either ▸▸I or I◂◂ briefly to change the frequency in 0.05 MHz
(VHF) or 9 kHz (MW) increments until the required frequency is set.
If no button is pressed for approx. two seconds, the automatic station search is
set again. The display will read AUTO.
6 stations can be saved in each frequency range.
♦
Keep one of the 1/PAU to 6/FL+ buttons (
2 seconds to store the station currently selected. The numbers 1 to 6 will
appear on the display to indicate a successful save.
♦
Press the SCAN/REC button
the FM band range.
The search stops for 5 seconds at each station found and then continues.
♦
If you want to listen to and save the station, press the SCAN/REC button to
stop the search.
♦
Keep one of the 1/PAU to 6/FL+ buttons pressed for about 3 seconds to
store the currently selected station. The numbers 1 to 6 will appear on the
display to indicate a successful save.
♦
Select the frequency range with the BND/ENT button.
♦
Press one of the 1/PAU to 6/FL+ buttons to call up the stored station.
to switch between FM (F 1, F 2, F 3) and
15
briefl y to start an automatic station search.
17
to search for stations with an AF signal in
18
–
) pressed for about
14
9
SAB 160 B2