Table of Contents
Advertisement
LTC 4600 Series | Instruction Manual | Installation
4
INSTALLATION
4.1
Installing Rack-mount Modules
1. Install the LTC 4637 Series card cage unit as
described in a later section of this document.
2. Install the fiber optic plug-in module into any
available slot of the LTC 4637 Series rack-mount
card cage. Certain modules, such as the LTC 4744
and LTC 4745 units are double width, so they
require two (2) available rack-mount slots.
•
Push the module in completely, so that the 3-pin
connector on the rear of the card engages the
3-pin connector on the back plane.
•
Each fiber optic plug-in module is equipped
with a power LED indicator that illuminates
when power is applied to the rack unit.
3. Fasten the module into place by tightening the front
panel captive screws into the appropriate mating
holes with a small flat blade screwdriver.
4. Connect the applicable video and/or data
connections to the appropriate connectors, located
either on the front or rear of the module. Refer to
the example diagrams later in the individual
sections.
Bosch Security Systems | September 20, 2004
4.2 Installing Stand-alone Modules
1. Choose an appropriate flat surface where the
stand-alone module can be conveniently mounted,
then mark the locations of the keyhole slots on the
mounting flanges.
•
The LTC 4641 Series Video Transmitter is small
enough to be installed inside a camera housing.
If applicable, mount the module in a convenient
location where it will not obstruct access to
other items in the housing.
2. Install the appropriate mounting screws (not
supplied) into the keyhole locations. Allow
sufficient leeway under the screw head for the
module to be mounted.
•
For the LTC 4641 Series Video Transmitter, a
single mounting hole is provided to secure the
module.
3. For modules other than the LTC 4641 Series,
position the module over screw heads, slide to one
side, and then tighten screws.
4. Connect the cable from the supplied power supply
to the power input terminals on the module.
5. Connect the supplied power supply to an
appropriate power source.
6. Connect the applicable video and/or data
connections to the appropriate connectors on the
module. Refer to example diagrams for exact
details.
EN | 8
Advertisement
Table of Contents
