Sealey ML13230V.V2 Instructions

thank you for purchasing a sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL
WARNING! Disconnect lamp from mains power before

performing any maintenance.
DO NOT shine lamp directly into your, other person's or animal's

eyes.
DO NOT allow children to use the lamp.

Maintain the lamp in good condition.

DO NOT use the lamp if the lamp if damaged.

When not in use store the light in a safe, dry, childproof location.

WARNING! Ensure Health and safety, local authority and

general workshop practice regulations are adhered to when
using this light.
Wear eye protection. A full range of safety equipment is

available from your sealey dealer.
Wear suitable clothing to avoid snagging.

DO NOT wear jewellery and tie back long hair.

Account for all tools being used and DO NOT leave them in or

near the engine.
1.2. ELECTRICAL SAFETY FOR USE OF TRANSFORMER. USE
ONLY THE SUPPLIED TRANSFORMER PLUG FOR
CONNECTING LAMP TO THE POWER SUPPLY.
WARNING! It is the user's responsibility to read, understand and

comply with the following electrical instructions: You must
ensure the risk of electric shock is minimised by the installation
of appropriate safety devices. An rccB (residual current
circuit Breaker) should be incorporated in the main distribution
board. We also recommend that an rcD (residual current
Device) is used with all electrical products, particularly portable
equipment which is plugged into an electrical supply not
protected by an rccB.
You must also read and understand the following instructions
concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable electrical
appliances, if used on business premises, to be tested by a
qualified electrician, using a Portable Appliance tester (PAt), at
least once a year.
 WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
© Jack sealey Limited
InstructIons for:
NEON LEAD LAMP 11W/230V
WITH 5MTR CABLE
MoDEL no: ML13230V.V2
1.2.2. The Health & Safety at Work Act 1974 makes owners of
electrical appliances responsible for the safe condition of the
appliance and the safety of the appliance operator. If in any
doubt about electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
Inspect the transformer plug, cable and connector for wear and

damage to ensure items are safe before connecting to the
mains power supply. If worn or damaged DO NOT use.
Important: check that the voltage marked on the transformer

plug is the same as the power supply to be used.
uncoil the cable between transformer plug and lamp.

DO NOT pull the transformer plug from the mains socket by the

lead.
DO NOT use any other type of transformer with this product.

DO NOT try to take the transformer plug apart.

DO NOT use the transformer plug to power any other electrical

item.
DO NOT get the transformer plug wet, or use in wet, damp

conditions (for indoor use only).
WARNING! NEVER substitute a standard 13amp 3 pin plug, or

any other type of plug, for the transformer plug.
this transformer plug reduces and rectifies the mains voltage
(230 volts Ac) to 12 volts DC.
Original Language Version
ML13230V.V2 Issue: 1 - 04/07/13