Advertisement
H-8931
DEWALT
10 GALLON
®
WET/DRY VACUUM
Vacuum x 1
MODEL
Tank Capacity
Power
Motor
Hose
Power Cord
WARNING: Use only extension cords that are
rated for outdoor use. Extension cords in poor
condition or that are too small in wire size
can pose fire and shock hazards. To reduce
risk of these hazards when using an extension
cord, ensure it is in good condition and that
connection does not come into contact with
liquid.
PAGE 1 OF 7
1-800-295-5510
uline.com
1⁄" Durable
Hose x 1
Utility
Nozzle x 1
PRODUCT SPECIFICATIONS
H-8931 (DXV10SB)
10 Gallon
120 V / 60 Hz / 10 A
Single Stage
1⁄" x 7'
20'
PARTS
Extension Wand x 2
Floor Nozzle x 1
Accessory Bag with
Disposable Filter
Holder x 1
NOTE: To keep power loss to a minimum, use
the following table to choose the minimum
wire size extension cord.
EXTENSION CORD LENGTH
0 - 50'
50 - 100'
Car Nozzle x 1
Cartridge
Bag x 1
Filter x 1
GAUGE (A.W.G.)
Round
Brush x 1
14
12
0321 IH-8931
Advertisement
Table of Contents
Related Manuals for DeWalt DXV10SB
Summary of Contents for DeWalt DXV10SB
- Page 1 Bag x 1 Filter x 1 Vacuum x 1 PRODUCT SPECIFICATIONS NOTE: To keep power loss to a minimum, use MODEL H-8931 (DXV10SB) the following table to choose the minimum Tank Capacity 10 Gallon wire size extension cord. Power 120 V / 60 Hz / 10 A EXTENSION CORD LENGTH GAUGE (A.W.G.)
-
Page 2: Definitions: Safety Guidelines
DEFINITIONS: SAFETY GUIDELINES Definitions below describe the level of severity for each CAUTION: Indicates a potentially hazardous signal word. situation that, if not avoided, may result in minor or moderate injury. DANGER: Indicates an imminently hazardous situation that, if not avoided, will result in death NOTICE: Indicates a practice not related to or serious injury. - Page 3 SAFETY CONTINUED • An extension cord must have adequate wire size WARNING: Servicing of double insulated wet/ (AWG or American Wire Gauge) for safety. The dry vacuum in a double-insulated wet/dry smaller the gauge number of the wire, the greater vacuum, two systems of insulation are provided the capacity of the cable.
-
Page 4: Operation
OPERATION ACCESSORY BAG HOLDER BRACKET Pull lid latches in outward motion, remove power head and any accessories that may have been ASSEMBLY shipped in tank. Place accessory bag holder into hole of bracket. 2. Attach accessories following these instructions. (See Figure 2) 3. - Page 5 OPERATION CONTINUED WET PICK-UP NOTE: The unit is ready for dry vacuuming or blowing. Plugging power cord into the wall receptacle, turn the unit "ON" by pushing the Cartridge filter must be positioned over filter cage while switch position. (See Figure 3) vacuuming liquids.
-
Page 6: Blowing Operation
OPERATION CONTINUED EMPTY THE TANK BLOWING OPERATION WARNING: To reduce the risk of injury from WARNING: Always wear safety goggles accidental starting, unplug power cord before complying with ANSI Z87.1 (or in Canada emptying dust tank. CSA Z94.3) when using as a blower. Remove power head assembly of wet/dry vacuum WARNING: To avoid injury to bystanders, keep by pulling outward on lid clips located on each side... -
Page 7: Maintenance
MAINTENANCE INSTALLING THE CARTRIDGE FILTER IMPORTANT: After cleaning, check the filter for tears or small holes. Do not use a damaged The cartridge filter can be used for wet or dry pick-up. filter. A small hole can cause dust to come out Installation is same for both.
Need help?
Do you have a question about the DXV10SB and is the answer not in the manual?
Questions and answers
Vacuum won't turn on. Filter in place, and it was working when last turned off. What should I do?
If your DeWalt DXV10SB vacuum won't turn on, follow these steps:
1. Ensure the power cord is securely plugged into a working wall outlet.
2. Check if the unit was previously turned off due to overheating. If so, allow it to cool down before restarting.
3. Inspect the power switch to ensure it is in the "ON" position.
4. Examine the power cord for any visible damage.
5. If the vacuum still does not turn on, consider contacting DeWalt customer support for further assistance.
This answer is automatically generated