Supplies4Heat SAXON Fitting Instructions

SAXON
Fitting Instructions
Aluminium Radiator in White
Horizontal and Vertical
Please read these instructions and terms and conditions carefully
prior to installation. Failure to do so may invalidate the warranty.
Drawings
Drawing 1 - Bush Configurations
Tighten 'S'
Anti-clockwise
SAXON radiators have specific left and right hand threaded
bushes and these can be easily damaged if forced or incorrectly
fitted (this will inevitably cause leaks). Bushes require a dry fit
connection only; you must not use any Compound materials
(e.g. Jet Blue) or Plumbers Hemp. If you choose you may use
up to 4 turns of PTFE tape to help seal the threads (the tape
should be applied in the direction of the thread and no more
than this amount should be used as this may cause leaks to occur)
If looking directly at the front of the radiator, the two
bushes with an 'S' cast on them are positioned on the
left and turned anti-clockwise. The two bushes cast with
a 'D' are positioned on the right and turned clockwise.
Please see Drawing 1
Pipe Centres
Pipe centres left to right
Pipe centres from wall
Depth from wall
www.supplies4heat.co.uk
SAX_IR_1.1
Tighten 'D'
Clockwise
= width of radiator plus valves
= 70mm
= 120mm
Drawing 2 - Bracket Positions
2 x Left
Hand
Brackets
01342 306880
2 x Right
Hand
Brackets