How To Load And Carry Out A Programme - Siemens SIMATIC OP7 Manual

4.6

HOW TO LOAD AND CARRY OUT A PROGRAMME

• The programme to be carried out must always be
present in the work memory (OP7).
• If the programme is not present in the work memory
(OP7), it will have to be loaded from the MICRO PLC
according to the following procedure.
Move on to the page shown on the right as follows:
• "ESC" key if you have been programming and you want to
carry out the cycle that is still inside the memory
• Key "K3" if you were carrying
out other functions
ESC
• Press
repeatedly
SHIFT
ENTER
Cycles Menu
Program edit
Loop table
Save program
Load program
Delete program
Ripetition
Ver. curr. progr.
Choice
Start progr.
Monitoring
LOAD PROGRAM
< ESC > Prev. menu
Program to load
Load program
(*) if the selected position does not contain a programme, the following flashing
message will appear
(Keep a note of the saved programmes)
Cycles Menu
Choice
Start progr.
Monitoring
Choice
Start progr.
Monitoring
THE PROGRAMME IS CARRIED OUT
SIEMENS SIMATIC OP7
F1 F2 F3
K1 K2 K3
7 8 9
4 5 6
1 2 3
. INS
0 +/-
SHIFT HELP
DEL
OP7
RAM work memory
Q1
Q2
: (1)
: (2)
: (3)
: (4)
Q3
: (5)
: (6)
: (7)
Q4
4
to load a programme into the memory
STOP
: OFF
Q5
1 to select programme 1 (*)
LOAD to load the programme into the memory
Position empty
<ENTER> to exit
Q6
to load the programme into the memory
Q7
STOP
: OFF
Q8
Turn to ON if you wish to visualize the
START
cycle during its execution
OFF
Q8
in order to visualize the programme
during its execution, please refer to
paragraph 4.10.
35
F4
MICRO
K4
ESC
ACX
ENTER
PLC