GE Multilin 369 Quick Start Manual page 30

CONNECTING ENERVISTA 369 SETUP TO THE RELAY
Note
3–26
Expand the Settings > Relay Setup list item and double click on Front
Panel to open the Front Panel settings window as shown below:
FIGURE 3–3: Main Window After Connection
The Front Panel settings window will open with a corresponding status indicator
on the lower left of the EnerVista 369 Setup window.
If the status indicator is red, verify that the serial or Ethernet cable is
properly connected to the relay, and that the relay has been properly
configured for communications (steps described earlier).
The Front Panel settings can now be edited, printed, or changed according to user
specifications. Other setpoint and commands windows can be displayed and edited in a
similar manner. Actual values windows are also available for display. These windows can
be locked, arranged, and resized at will.
Refer to the EnerVista 369 Setup Help File for additional information about using the
software.
CHAPTER 3: USER INTERFACES
369 MOTOR MANAGEMENT RELAY – QUICKSTART GUIDE