Sealey HT105LED Instruction Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS
INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY.
PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. GENERAL
 WARNING! Disconnect lamp from mains power before performing
any maintenance.
 DO NOT shine lamp directly into your, other person's or animal's
eyes.
 DO NOT allow children to use the lamp unsupervised.
 Maintain the lamp in good condition.
 DO NOT use the lamp if the lamp if damaged.
1.2. ELECTRICAL SAFETY FOR USE OF
TRANSFORMER. USE ONLY THE SUPPLIED
TRANSFORMER PLUG FOR CONNECTING LAMP TO THE POWER
SUPPLY.
 WARNING! It is the user's responsibility to read, understand and
comply with the following electrical instructions:
You must ensure the risk of electric shock is minimised by the
installation of appropriate safety devices. An RCCB (Residual
Current Circuit Breaker) should be incorporated in the main
distribution board. We also recommend that an RCD (Residual
Current Device) is used with all electrical products, particularly
portable equipment which is plugged into an electrical supply not
protected by an RCCB.
You must also read and understand the following instructions
concerning electrical safety.
1.2.1. The Electricity At Work Act 1989 requires all portable
electrical appliances, if used on business premises, to be tested by a
qualified electrician, using a Portable Appliance Tester (PAT), at least
once a year.
 WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood that common sense and caution are factors which must be applied by the operator.
© Jack Sealey Limited
INSTRUCTION MANUAL FOR
CORDLESS HEAD TORCH CREE LED 3W
RECHARGEABLE
HT105LED.V2
MODEL NO :
1.2.2. The Health & Safety at Work Act 1974 makes owners of
electrical appliances responsible for the safe condition of the appliance
and the safety of the appliance operator. If in any doubt about
electrical safety, contact a qualified electrician.
1.2.3. You must ensure that you:
 Inspect the transformer plug, cable and connector for wear and
damage to ensure items are safe before
connecting to the mains power supply. If worn or damaged DO NOT
use.
 Important: Check that the voltage marked on the transformer plug is
the same as the power supply to be used.
 Uncoil the cable between transformer plug and lamp.
 DO NOT pull the transformer plug from the mains socket by the
lead.
 DO NOT use any other type of transformer with this product.
 DO NOT try to take the transformer plug apart.
 DO NOT use the transformer plug to power any other electrical item.
 DO NOT get the transformer plug wet, or use in wet, damp
conditions (for indoor use only).
 WARNING! NEVER substitute a standard 13amp 3 pin plug, or any
other type of plug, for the transformer plug.
This transformer plug reduces and rectifies the mains voltage
(230 volts AC) to 3.7V DC.
Original Language Version
:
HT105LED.V2 Issue: 1 - 29/03/16