Brocade Communications Systems MLXe Series Hardware Installation Manual page 219

NOTE
If you did not remove the extra shipment screws from the router during installation, you will not be
able to remove the fan tray assembly. You will need to remove the router from the rack to remove
the shipping screws, (refer to the installation chapter appropriate for your router model) before you
can remove the fan tray assembly.
Follow these steps to replace fan tray assemblies in 4-slot routers.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector on
2. To remove the fan tray assembly from the router, push down on the latch release with your
DANGER
Be careful not to insert your fingers into the fan while removing it. The fan may still be spinning at
a high speed.
FIGURE 115
Brocade MLXe Series Hardware Installation Guide
53-1003030-01
the router.
thumb, grasp the handle, and pull it toward you as shown in
the assembly unseats the fan tray assembly connector from a router connector.
Replacing the fan assembly in a Brocade MLXe 4-slot router
Replacing fan assemblies
Figure 115 and Figure 116. Pulling
6
207