General Warnings - ALLFASTENERS AFGN50 ProTrax Safety & Operation Manual

3. DANGER WARNINGS (CONT'D)
120°F
(50°C)
Maximum

4. GENERAL WARNINGS

1. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
Always assume the nailer contains fasteners. Never point the nailer at yourself or others, whether it contains fasteners
or not. If fasteners are mistakenly driven, it can lead to sever injuries.
2. KEEP FINGERS AWAY FROM TRIGGER WHEN NOT DRIVING FASTENERS TO AVOID ACCIDENTAL FIRING.
To prevent accidental misfire of fastener and injury to yourself or others, never carry the nailer with finger on trigger. Always carry the
nailer by the handle only.
3. ALWAYS WEAR EAR AND HEAD PROTECTION.
Always wear ear protection to further protect from loud noise and ear damage. Always wear head protection to ensure protection
from flying materials or misfire of nailer.
4. USE OUTDOORS OR IN WELL-VENTILATED AREAS.
This nailer should not be used in enclosed or poorly ventilated work areas. This nail creates carbon monoxide exhaust which
is dangerous to health when inhaled. DO NOT inhale.
5. PROPERLY STORE NAILER WITH FUEL CELL AND BATTERY REMOVED.
When not in use, the nailer, fuel cell and battery should be stored by placing pieces individually in tool case. Store case in a dry place,
indoors at temperatures between 41°F (5°C) - 77°F (25°C). Keep the nailer, fuel cell and battery out of direct sunlight and do not leave
in hot vehicle. Keep out of reach of children and lock in storage area when possible.
6. KEEP WORK AREA CLEAN.
Cluttered areas can result in higher risk of injury. Clear all work areas of unnecessary tools, debris, furniture, etc.
7. KEEP UNAUTHORIZED USERS AWAY FROM TOOLS.
Do not let unauthorized users handle nailer, fuel cell or battery. All users must comply with safety requirements and precautions while
operating.
8. DRESS PROPERLY.
Do not wear loose clothing or jewelry as they can be caught in moving parts. Rubber gloves and nonskid footwear are recommended
when working outdoors. Wear protective hair covering to ensure safety against moving parts.
9. CHECK PUSH LEVER BEFORE USE.
Remove fuel cell and battery, and then make sure the push lever operates properly before use. Never use nailer unless the push lever
is operating poorly, otherwise the nailer could drive a fastener unexpectedly. Do not tamper with or remove push lever, otherwise the
push lever may become inoperable or dangerous.
10. KEEP ALL SCREWS AND COVERS TIGHTLY IN PLACE.
Keep all screws and covers tightly mounted and make sure to check their condition periodically. Never use the nailer if parts are
missing or damaged.
11. DO NO LOAD FASTENERS WITH TRIGGER OR PUSH LEVER DEPRESSED.
When loading fasteners in to the nailer 1) DO NOT depress the trigger, 2) DO NOT depress the push lever and 3) Keep the nailer
pointed downward.
12. KEEP FACE, HANDS AND FEET AWAY FROM FIRING HEAD DURING USE.
Never place your face, hands or feet closer than 8 inches (20mm) from the firing head. A serious injury can occur if the fasteners are
deflected by the work surface, or are driven away from the point of entry.
Keep the nailer, fuel cells and battery away from sunshine and from temperatures exceeding
120°F (50°C). Fuel cell and/or battery may burst, releasing flammable gases if temperature is
too high. DO NOT pierce or burn the container even after use. DO NOT incinerate, refill,
reclaim or recycle the fuel cell cartridge. DO NOT spray near open flame or heat sources.
Keep away from ignition sources. No smoking near materials. Keep out of the reach of children.
ALLFASTENERS.COM | 3