Steps
1. Align and place the power adapter port on the palmrest assembly.
2. Install the (M2x3) screw to secure the power adapter port to the palmrest assembly.
3. Connect the power adapter port to the connector on the system board.
4. Install the (M2.5x4) and two (M2.5x6) screws to secure the display hinges to the system.
Next steps
1. Install the
base
cover.
2. Exit the
service mode
3. Install the
SIM card tray
4. Install the microSD-card.
5. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
2. Remove the microSD-card.
3. Remove the
SIM card tray
4. Enter the
service
mode.
5. Remove the
base
cover.
6. Remove the
WWAN card
About this task
NOTE:
If the CMOS battery is disconnected from system board for service, there will be a delay during system boot as the
system undergoes RTC battery reset.
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
58
Removing and installing components
for 4G LTE enabled systems.
after working inside your
before working inside your
for 4G LTE enabled systems.
for 4G LTE enabled systems.
computer.
computer.
Need help?
Do you have a question about the Latitude 3520 and is the answer not in the manual?
Questions and answers