Honda SCOOPY i 2020 Owner's Manual page 76

Change the engine oil with the Idling Stop
switch at IDLING.
1. If the engine is cold, idle the engine for 3
to 5 minutes.
2. Turn the ignition switch to the
position and wait for 2 to 3 minutes.
3. Place your vehicle on its centre stand on a
firm, level surface.
4. Place a drain pan under the drain bolt and
oil plug.
5. Remove the oil fill cap/dipstick, drain bolt
and sealing washer to drain the oil.
6. Remove the oil plug, O-ring, spring and
oil strainer screen and let the remaining
oil drain out.
Discard the oil at an approved
u
recycling centre.
7. Clean the oil strainer screen.
Engine Oil Changing Engine Oil, Cleaning Strainer Screen
u
8. Check that the oil strainer screen and
sealing rubber are in good condition.
9. Replace the O-ring and apply a thin coat
of engine oil to the new O-ring before
installing it.
(Off)
10. Install the oil strainer screen, spring and oil
plug and tighten
Torque: 20 N·m (2.0 kgf·m, 15 lbf·ft)
Sealing washer
Drain bolt
continued
71