Advertisement
4.5. Pressure Unit Selection mode.
4.5.1.
The default pressure unit setting is psi.
4.5.2.
To change the pressure units, select mode 2 as at 4.3.2. and 4.3.3.
4.5.3.
After selecting mode 2 a dash will appear at the bottom of the display, corresponding to the units displayed at the
top (psi, bar or MPa).
4.5.4.
When the dash corresponds to the required setting, press the button to select.
4.5.5.
The selected unit will flash 3 times. After showing 'End' , the unit will switch off.
5. OPERATION
5.1. Mount the regulator/gauge in a convenient location in the air inlet circuit, ensuring that all connections are tight.
5.2. To adjust the pressure, turn the adjusting knob clockwise to reduce and anticlockwise to increase.
6. BATTERY REPLACEMENT
6.1. To replace/remove batteries:
Replacement battery type: LR44 / AG13 / L1154. Alkaline button cell 1.5V
6.1.2.
Remove the 4 screws securing the casing (fig.1).
6.1.3.
Remove the printed circuit board by removing the 2 screws (fig.2).
6.1.4.
On the reverse of the printed circuit board, remove the batteries by
driving out the battery retainers with a small screwdriver (fig.3).
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging
should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the
environment. When the product becomes completely unserviceable dispose of it according to local
regulations.
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste
Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. Contact your local solid waste authority for recycling information.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of
products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance
scheme.
Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705
NOTE: It is our policy to improve products continually and as such we reserve the right to alter data, specifications and
component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim
© Jack Sealey Limited
Environmental Protection
Sole UK Distributor, Sealey
Group, Kempson Way, Suffolk
Business Park, Bury St.
Edmunds, Suffolk,IP32 7AR
Original Language Version
WEEE Regulations
01284 757500
01284 703534
fig.1
fig.1
fig.1
fig.2
fig.3
fig.2
.
www.sealey.co.uk
.
sales@sealey.co
uk
ARD01 Issue: 1 - 02/06/16
Advertisement
