9 Invictus OSD ............................16 9.1 PIN Number ............................. 16 10 OSD Operation/Navigation ........................17 11 Locating the Invictus Hybrid on your Network ..................22 12 Connecting to the Invictus Hybrid......................22 12.1 Live View ............................24 12.1.1 Live Video ..........................24 12.1.2 Status .............................
6. 360 Vision Technology Limited accept no liability for any damage caused by incorrect or improper installation. 7. To prevent risk of injury caused by the Invictus Hybrid or mounting options becoming detached, fit a suitable safety chain or lanyard.
Page 12 6 Connections to Invictus with HMA When the HMA (Hinged Mount Adaptor) is fitted to the Invictus Hybrid, the ‘Invictus Composite Cable’ is not used. Connections between the power supply and Invictus use conventional cables as detailed below.
8 Invictus Protocol/Address setup. All Invictus cameras are supplied set to 360 Vision protocol, camera twisted pair address 1. When the Invictus is switched on, an OSD (On Screen Display) is shown on the image from the camera for approx 20 seconds.
Page 19
• White When Alarm - Set if white lights are to be used if an alarm is triggered. This feature works with 360 Standalone alarmcard or 360 Vision Matrix only. • White Timeout - Use if a white light timer is required. Default is on.
360 Event 9001 TCP 12 Connecting to the Invictus Hybrid Type in the IP address of the Invictus Hybrid into the address bar of Mozilla Firefox. The web page of the camera will then appear. Invictus Hybrid Web Page Login screen...
Choice of analogue or digital/IP video output. Camera will perform an automatic reboot when this option is changed. OK to program the new settings into the Invictus Hybrid. Cancel to abandon the changes to the video settings. 12.2.2 Video Advanced Multicast Tick the box to enable ‘multicast’.
Page 28
If the receivers of the video streams are suitable for using ‘multicast’ and the video streams will all have the same format, then it may be possible to use ‘multicast’. In this mode, the CODEC in the Invictus Hybrid chooses a ‘new UDP address’...
Invictus Installation Manual V2.1.25.3 Page 29 12.2.3 Advanced Features The Advanced Features page, offers options to:- • Camera - Cannot be edited, shows label/name given to the camera. (See section Video - Camera - page 26). A ‘Preset’ is a stored view. When a preset is defined, it will store the pan, tilt, zoom, focus and iris positions. Use the up, down left and right buttons to move the camera to the desired position and then use the zoom buttons to set the image as required.
Page 30
Preset Tour A tour of presets is stored in the Invictus Hybrid as a list of tour points. Each tour point consists of a preset number, the dwell time for which the Invictus Hybrid will pause and the speed parameter that will be used to seek the preset.
Auto Focus/Iris on PTZ - Auto focus/iris will activate when PTZ is used, can be switched off. Default is • Fast Shutter - Select fast shutter if using the Invictus Hybrid camera on a ANPR system. Default is off. (See page 43 for table of options).
Page 32
Invictus Hybrid. The maximum amount of picture stability is achieved for all zoom settings. The part of the picture that is wasted reduces the resolution of the viewed picture when the camera is set to 1080P and steady shot is selected.
Auto Dimming - When selected the camera will reduce the lamp power, when looking in scenes where there is to much light. OK to program the new settings into the Invictus Hybrid. Cancel to abandon the changes to the settings.
• Time Zone Time Zone - Select time zone to suit the location of the camera/system. • OK to program the new settings into the Invictus Hybrid. Cancel to abandon the changes to the settings. 12.2.6 Network • Camera - Cannot be edited, shows label/name given to the camera.
802.1x Authentication • Authentication - Tick to enable 802.1x. Options to choose MD5 or TLS and add username/password. OK to apply the new settings into the Invictus Hybrid. Cancel to abandon the changes to the network settings. 12.2.7 Interfaces Camera - Cannot be edited, shows label/name given to the camera.
DO NOT interfere with this process as it may stop the camera from working. Visit the camera Browser page (Framework), 360 Vision Technology web site or contact 360 Vision Technical Support for the link to the update application & codec update files.
Invictus Hybrid from the network and control it locally using a network connection to a laptop so that the IP address can be set to a suitable setting before the Invictus Hybrid is reconnected to the main network.
When the Invictus Hybrid is installed in areas where there is a high risk of damage from birds or their droppings, additional precautions and measures should be used to keep the birds away from the Invictus Hybrid e.g. fit anti-bird spikes.
Need help?
Do you have a question about the Invictus Hybrid and is the answer not in the manual?
Questions and answers