Tarptent StratoSpire Li Quick Start Manual

Tarptent StratoSpire Li
Setup
Please watch the setup video. It will take about 2 minutes once you do it a few
times.
https://www.tarptent.com/product/stratospire-li/
1. Spread canopy on ground, floor side down. Remove stakes from stake bag
and have ready. Set trekking poles to about 125cm/49in.
2. Stake one vestibule door side so that the fabric is reasonably taut. Leave
about 6 in / 15cm of cording. Insert trekking pole, handle end first, through
vent opening so that pole tip goes into grommet on underside of vent.
3. Pull canopy ridgeline out. Insert second pole through other vent into
grommet. Stake opposite door so that door corners are taut and poles are
vertical.
Stake
Insert trekking pole
Stake
4. Restake corners as necessary so that the canopy corners form a rectangle,
the fabric is flat across the sides, and the ridgeline is taut.
ridgeline tension
Stakes
Stake
Insert trekking pole
Stake
Stakes
5. Now pull out each Pitchloc strut supported corner firmly and stake through
plastic loop.
6. Walk around the perimeter and use the line tighteners to tighten fabric.
Pull to tighten
7. Unzip either door and roll back. Secure to magnetic closure strap.
8. Adjust floor straps at ground level to even floor tension and straps at apex of
interior to even interior fabric tension.
9. For more ridgeline tension and to fully open fly sides, attach apex guylines
and pull out to either door stake and tighten.
10. For best ridgeline tension, stake guyline separately midway between door
stakes.
Pull to tighten
Pull to tighten