Anywire BL287SB-02F-CC20 Product Manual page 10

[Data Configuration]
BL287SB-02F-CC20, BL287SB-02FS-CC20
Address
n+1
offset
Bit input IN1 IN0
BL287PB-02F-CC20, BL287PB-02FS-CC20
Address
n+1
offset
OUT1 OUT0
Bit output
BL287XB-02F-CC20, BL287XB-02FS-CC20
Address
n
offset
IN
Bit input
OUT
Bit output
■Status details
The contents of an alarm detected with this unit can be checked with the "status detail area
on the master unit.
A bit corresponding to the status detail area turns ON depending on the contents of the alarm.
Status detail area of the master unit
Status
b15 b14
details
b0: Slave unit voltage drop (DP-DN-side voltage drop)
b5: I/O power supply drop (24V-0V-side voltage drop)
* 1 This can be used on the master unit having the status detail area. For details, refer to the manual for the master unit.
[Monitor Display]
LED name Display status
Lit
LINK
Flashing
(Green)
Unlit
Lit
ALM
Flashing
(Red)
Unlit
Alternate ashing
LINK
LINK
ALM
ALM
LINK
LINK
ALM
ALM
Lit
I/O
(Orange)
Unlit
* 2 This indication appears when the use of the single unit simpli ed replacement function fails.
(This operation occurs on the S/W version "B" or later version.)
* 3 If ID duplication is detected when the master unit executes automatic address recognition,
this indication appears.
* 4 When transmission signal and power supply are normally connected and this unit is set to
the factory-set address, this indication appears.
n
* n = Bit address number assigned to this unit
n
b13 b12 b11
Description
Transmission signal error
Model mismatching error *
Transmission signal received
No transmission signal (disconnection and
reverse connection of DP and DN lines included)
I/O power supply drop
Slave unit voltage drop
Model mismatching error *
No ALM available
ID duplicated * or ID unregistered *
3
Model mismatching error *
ON
OFF
-BL287*B02F*CC20 10/16-
b10 b9 b8 b7
2
2
4
2
*
1
"
b6 b5 b4 b3
LINK (Green)
Setting port
I/O0 (Orange)
LINK
I/O0
I/O0
I/O1
I/O1
ALM
I/O1 (Orange)
ALM (Red)
LED indicators
If an error is indicated, identify a
cause of the error by checking
lit/ ashing status with the table
on the left, and eliminate the
cause of the error.
Once the cause of the error is
eliminated, the error indication
will be automatically reset.
b2 b1 b0