Balance charger/discharger for nicd/nimh/lithium/pb batteries (24 pages)
Summary of Contents for Thunder TDR02021
Page 1
THANK YOU FOR CHOOSING THE THUNDER DC TO DC BATTERY CHARGER For your personal safety, read, understand and follow the information provided in this instruction manual.
FEATURES & BENEFITS • Heavy duty aluminium case • Easy to read Bluetooth LCD screen • 12-24V system input (12V output) • 0-90°C Operating temperature • IP67 • MST (Modular Sense Technology) • Microchip monitoring and control • Fully automatic high frequency multi stage charging •...
IMPORTANT SAFETY WARNINGS FOR AUTOMOTIVE 12/24V USE ONLY, NOT TO BE USED WITH DRY CELL BATTERIES. To avoid any personal injury, please read the following safety instructions. This battery charger is not intended for use by young children or infirm persons without supervision. During the charging process, do not use a naked flame near a battery.
If the solar input is above 13V then the green LCD on the display will illuminate input yellow wire and the negative of the panel to the negative black wire (see to indicate that the TDR02021 is now using the solar input to charge the auxiliary specification table on page 8).
OUTPUT FUSE RATING Minimum 30A *When fitting the TDR02021 to a caravan, the cable will need to be connected to the towing 12.2V - 26V vehicle with a suitable heavy duty connector such as a 50A “Anderson” connector or similar.
INTEGRATED LCD DIAGRAM The Thunder 20A DC-DC now comes with an LCD interface screen, giving you better visibility on the health of your batteries charging inputs. While your vehicle is charging, the LCD screen will show in the vehicle car charging screen allowing you to see the main and auxiliary battery voltages, auxiliary battery percentage and how much current is flowing into the battery.
– Main NOTE: When you connect two or more TDR02021’s together, one unit will become the source unit and one will become a slave unit. This means the source unit will carry the majority of the charging load output and the slave will help when needed.
After one minute if voltage is over 12.6V the Thunder DC-DC goes to Stage 6. NOTE: If battery is determined to be faulty the Thunder DC-DC will stop charging. Stage Charging...
SOLAR CHARGING MODE 1. Stage 1: Direct solar energy to charge the battery until the battery voltage reaches When the auxiliary battery reaches 80% the Thunder DC-DC will automatically start to 14.5V, switches to stage 2. charge the main and auxiliary batteries.
WARRANTY TERMS & CONDITIONS When you acquire or fit a Thunder product you have the peace of mind in knowing that it is backed by a comprehensive 12 month warranty against defects in materials and workmanship. The Thunder warranty is provided in addition to any rights you may have under the Australian Consumer Law.
Page 12
GPC Asia Pacific GPC Asia Pacific 22 Enterprise Drive Rowville 22 Enterprise Drive Rowville Victoria 3178 Australia Victoria 3178 Australia 510 Mt Wellington Hwy 510 Mt Wellington Hwy Auckland New Zealand Auckland New Zealand thunderauto.com.au // thunderauto.co.nz thunderauto.com.au // thunderauto.co.nz...
Need help?
Do you have a question about the TDR02021 and is the answer not in the manual?
Questions and answers