peplink Pepwave Surf SOHO User Manual page 100

Operating Country This option sets the country whose regulations the Pepwave router follows.
SSID Select if an SSID is broadcasting on 2.4 Ghz, 5 Ghz or both bands
Protocol This option allows you to specify which client association requests will be accepted. By default,
802.11ng is selected.
Channel Width Settings for 2.4 GHz AP and 5GHz AP can be configured here:
2.4 GHz: 40 MHz, 20/40 MHz and 20 MHz are available. The default setting is 20/40 MHz, which allows
both widths to be used simultaneously.
80 MHz , 40 Mhz, 20 Mhz, and(20/40 MH) are available. The default setting is 80 MHz.
Note: 802.11ng and 802.11na are not part of the 802.11 standard. It is simply a notation for indicating
802.11n use on the 2.4-GHz band (11ng) or 802.11n use on the 5-GHz band (11na).
Channel This option allows you to select which 802.11 RF channel will be used.
Auto Channel Indicate the time of day for updating the automatic channel selection.
Update
Output Power This option is for specifying the transmission output power for the Wi-Fi AP. There are 4 relative power
levels available – Max, High, Mid, and Low. The actual output power will be bound by the regulatory
limits of the selected country.
Client Signal This field determines that maximum signal strength each individual client will receive. The measurement
unit is dBm.
A
Strength Threshold
Maximum number Enter the maximum number of clients that can simultaneously connect to the wireless network or enter
0 to allow an unlimited number of connections.
of clients
Beacon Rate A This option is for setting the transmit bit rate for sending a beacon. By default, 1Mbps is selected.
A
Beacon Interval This option is for setting the time interval between each beacon. By default, 100ms is selected.
A This field allows you to set the frequency for the beacon to include a delivery traffic indication message.
DTIM
The interval is measured in milliseconds. The default value is set to 1 ms.
RTS Threshold Set the minimum packet size for your access point to send an RTS using the RTS/CTS handshake.
Setting 0 disables this feature.
Fragmentation Determines the maximum size (in bytes) that each packet fragment will be broken down into. Set 0 to
disable fragmentation.
A
Threshold
https://www.peplink.com
Wi-Fi Radio Settings
Wi-Fi AP Settings
100 Copyright @ 2021 Peplink