Sharp AR-SS2 Service Manual page 9

[4] DISASSEMBLY AND ASSEMBLY
1. External fitting
To clean, check, or repair the machine, remove the cover of the
desired section in the following procedures.
For the covers that can be removed simply by removing the fixing
screws, the procedures are omitted.
1
4
1 Front cover (2)
2 Right cover (2)
3 Rear cover (2)
4 Stapler unit cover
5 Transport guide unit
Note When removing the front cover, be careful not to break the
connector that is at the back of the operation panel.
2. Bin unit
A. Bin unit removal
1) Remove the front cover, the right cover, and the rear cover.
2) Remove the four connectors (1) of the sorter controller PWB.
3) Remove the two screws (3) of the signal code plate (2), and
remove it.
1
5
3
2
2
3
4 – 1
4) Remove the two screws (4) on the front side and the two on the
rear side.
5) Lift the projection (5) of the accuride rail and remove the bin unit in
the arrow direction.
Note: Bin unit weight: About 10kg
4
6) Set down the removed bin unit as shown below.
Note: When assembling the bin unit, place the bin unit on the lead
cam from the upper side of the sorter body, rotate the clock
disc of the shift motor to engage the lead cam with the bin.
AR-SS2
5