Related Manuals for Hill-Rom LikoGuard L
Summary of Contents for Hill-Rom LikoGuard L
- Page 1 LikoGuard™ Overhead Lift Service Manual LikoGuard™ L Product No. 3301030 LikoGuard™ XL Product No. 3301040 3EN190401 Rev. 7 ENGLISH...
- Page 2 Components (manufacturing parts) are not available after last manufacturing date. Repairs and maintenance may only be performed by personnel authorized by Hill-Rom and using original Liko spare parts. ™ For information regarding Service and Maintenance education, contact your Hill-Rom representative. For contact information please visit our website: www.hill-rom.com...
-
Page 3: Table Of Contents
Table of Contents LikoGuard™ overhead lift Page 1.0 Technical Data 1.1 Dimensions ................4 1.2 PCB board Wiring Diagram ..........5 1.3 Rechargeable Li-Ion Battery ..........5 2.0 Troubleshooting 2.1 General Troubleshooting ..........6 2.2 Error Code - General Information ........7 2.3 Error Code - Service Advice ..........8 3.0 HandControl LG with display 3.1 Assembly of HandControl LG with display for service ..10 3.2 General Information ............11... -
Page 4: Technical Data
1.1 Technical Data Emergency Mechanical Maximum load L: 272 kg (600 Ibs.) lowering device: Electrical XL: 363 kg (800 Ibs.) Emergency raising: Electrical Battery: 25.2V / 4.2 Ah Duty cycle: 10/90 max. 2 min (0 - 272 kg) (0 - 600 Ibs.) Main board memory (Intermittent 5/95 max. -
Page 5: Pcb Board Wiring Diagram
1.2 PCB Board Wiring Diagram HAND CONTROL A Side: CHARGER EXTENDER CABLE ACTIVE LOAD BATTERY MCB PCBA 178162 MODULE ASSY 186199 KEY PAD, BATTERY POWER CONNECTOR MEMBRANE SWITCHES CLOCK BACKUP BATTERY BATTERY COMMUNICATION CONNECTOR EMERGENCY STOP MOTOR 1 UP LIMIT SWITCH POTENTIOMETER MOTOR 2 B Side:... -
Page 6: General Troubleshooting
1. Charge the LikoGuard™ Overhead lift. 2. If the lift still does not work satisfactorily, please contact Hill-Rom. In the event of excessive noise from the lift! Please contact Hill-Rom. Service Manual LikoGuard™ • 3EN190401 Rev. 7 www.hillrom.com overhead lift... -
Page 7: Error Code - General Information
2.2 Error codes - General Information HandControl LG with display Shows the last 10 error messages. Advanced Error Message Service (No.1 is the most recent) Usage Service Reset Reset Error Message Advanced menu Error Codes from the HandControl with display: The error code consists of 4 digits. -
Page 8: Error Code - Service Advice
Service advice: code 0310 Motor current inrush error 5 minute time out before the system If error repeats; Contact Hill-Rom is operational again 0311 Current difference greater than 5 minute time out before the system If error repeats; Contact Hill-Rom... - Page 9 Error Meaning: Recovery: Service advice: code 0a06 Bus communication error System will stop articulation until If error repeats; Contact Hill-Rom error clears 0a07 Bus communication error System will stop articulation until If error repeats; Contact Hill-Rom error clears 0a0b Bus communication error System will stop articulation until If error repeats;...
-
Page 10: Assembly Of Handcontrol Lg With Display For Service
3.1 Assembly of HandControl with display, for service HandControl LG 2-Button with display Product No. 3306020 kg/lbs Tools required: Before assembly: • ESD protection is required. When the HandControl with display is required for service and the HandControl without display is attached to LikoGuard™... -
Page 11: General Information
3.2 General Information kg/lbs 1. Operation Lift movement is based on the HandControl being held in the direction shown in the picture. The movement stops when the button is released. Down Lift movement is based on the HandControl being held in the direction shown in the picture. -
Page 12: Pop-Up Messages
3.3 Pop-Up messages Symbols and Information (pop-up message) A pop-up message is displayed on screen for 5 seconds or until any button on the HandControl is pressed. Overload Overload (operating time)! (maximum load)! To Menus! Service required Open menus press Overload Service required Overload... -
Page 13: Next Service
3.4 Next Service Menus and information In the display window main menu there are two choices; Usage and Service. The Usage menu is described in the Instruction Guide. In the Service menu it is possible to choose between 14 different languages for the display menu. To menu press 2 seconds - To display Main menu;... -
Page 14: Password
3.6 Password Advance Service menu is password protected and intended for use by service technicians authorized by Hill-Rom. Password: 920 Enter each digit, using the arrow key. Confirm by pressing Service Password Password Password 3.7 Reset Service Reset Service only after performed approved Periodic Inspection, according to chapter 6. -
Page 15: Power Consumption
3.8 Power Consumption Advanced Power Consuption Total Power consumption (Ah). (Will never be reset.) Power Consumption (Ah) since last Service Reset. 3.9 Transfer Motor Advanced Transfer motor Not in use! 3.10 Overload Shows total number of stops due Advanced Overload System to overload. -
Page 16: End Position
3.11 End position Advanced End Position Shows the total number of stops due to activation of upper limit switch. (Will never be reset.) Shows the total number of stops due to lower end position reached. (Will never be reset.) 3.12 Error Message Advanced Error Message Shows the last 10 error messages. -
Page 17: Data Storage
Data Transfer Transfer Transfer If transfer failed: - Try one more time - Make sure Data storage is done - Make sure all connections are properly assembled. - Contact Liko/Hill-Rom Service Manual LikoGuard™ • 3EN190401 Rev. 7 www.hillrom.com overhead lift... -
Page 18: System
3.16 System Advanced Main Board System HW ver: Current hardware version of ###### the Main Board. ###### SW ver: Current software version of the Main Board. Pendant System HW ver: Current hardware version of ###### the HandControl (Pendant). ###### SW ver: Current software version of the HandControl (Pendant). -
Page 19: Spare Parts Positions
4.0 Spare Parts Positions LikoGuard ™ overhead lift Spare Parts Positions LikoGuard™ overhead lift Spare Parts Positions PROD. NO. PRODUCT 3301030 LikoGuard L 3301040 LikoGuard XL Plastic Covers L Plastic Covers XL Plastic Covers (top and bottom) L Plastic Covers (top and bottom)XL... -
Page 20: Spare Parts Assembly Information
- Make sure the spare part is mounted according to the assembly instruction. Document Number - Check all functions related to the changed spare part. - Repairs and maintenance may only be performed by personnel authorized by Hill-Rom and using original Liko™ spare parts. 3EN650203 Rev. 5 ENGLISH www.hill-rom.com... -
Page 21: Spare Parts List
6.0 Spare Parts List LikoGuard™ overhead lift PROD. NO. POS. NO. NAME UNIT ASSEMBLY INSTR. 33090001 Plastic Covers L, 2 pices pair 3EN690246 33090002 Plastic Covers XL, 2 pices 3EN690246 33090003 Plastic Covers (top and bottom) L 3EN690247 33090004 Plastic Covers (top and bottom)XL 3EN690247 33090005 Main Board L... - Page 22 6.0 Spare Parts List LikoGuard™ overhead lift PROD. NO. POS. NO. NAME UNIT ASSEMBLY INSTR. 33090013 Upper Limit Switch pair 3EN690255 33090014 Panel board, green 3EN690256 33090015 Key Pad, emergency lowering 3EN690257 (incl cables) 33090016 Lift strap with strap guide 3EN690258 33090017 Electrial Motors...
- Page 23 6.0 Spare Parts List LikoGuard™ overhead lift PROD. NO. POS. NO. NAME UNIT ASSEMBLY INSTR. 33090023 Carriage Plastic Wheels, 4 pairs 3EN690265 (with bearings) 33090024 HandControl Main Board Cable 3EN690266 33090025 Plastic grommet, 10 pce 3EN690267 33090026 Main Board Housing 3EN690268 33090027 Step-Up Box...
-
Page 24: Periodic Inspection Information
Post Code Liko™ overhead lifts must be thoroughly inspected at least once per year. Inspection and service must be carried out by Hill-Rom authorized personnel. If the lift is installed in a corrosive environment such as indoor pool or bathroom, see inspection point 11 before starting inspection. -
Page 25: Preventive Maintenance
Expected Life Time The expected life time of a LikoGuard™ Overhead Lift is 10 years of normal use (see table below) provided that recommended Periodic Inspection and Preventive Maintenance is performed by personnel authorized by Hill-Rom and using original Liko spare parts. -
Page 26: Installation Instructions
9.0 Installation Instructions Prod No. Prod Name Max Load 3301030 LikoGuard™ L, Overhead Lift 272 kg (600 lbs) 3301040 LikoGuard™ XL, Overhead Lift 363 kg (800 lbs) 3307010 Carriage 363 kg (800 lbs) Before installation: Read and understand the contents of the Overhead System Installation Hand Book. Make sure the maximum load of the installed railsystem is equal to or larger than the maximum load of the LikoGuard overhead lift. -
Page 27: Product Changes
10.0 Product Changes LikoGuard™ overhead lift Prod. No 3301030, 3301040 2020 Improved design of emergency stop. SUS003443 LikoGuard L from S/N 2203750 LikoGuard XL from S/N 2301900 Improved mechanical lowering. SUS003644 LikoGuard L from S/N 2203500 LikoGuard XL from S/N 2301700... - Page 28 www.hillrom.com Liko AB Nedre vägen 100 SE-975 92 Luleå , Sweden...
Need help?
Do you have a question about the LikoGuard L and is the answer not in the manual?
Questions and answers