Introduction; Resources - Daktronics Sportsound SSR-200 Operation Manual

Section 1:
This manual explains the operation of the Sportsound
the safety, installation, operation, or service of this system, refer to the telephone numbers listed in Section 6.
This manual is not specific to a particular installation. Project-specific information takes precedence over any
other general information found in this manual.
ImpoRtAnt SAfeguARDS
• Read and understand all instructions before beginning the installation process.
• Do not drop the control equipment or allow it to get wet.
• Do not disassemble control equipment or electronic controls of the system; failure to follow this
safeguard will make the warranty null and void.
• Always turn off and/or unplug the control equipment when it is not in use. This keeps equipment
protected from power spikes and lightning.
• Never yank the power cord from the outlet. Grasp the plug and pull to disconnect.
• Do not let any power cord touch hot surfaces or hang over the edge of a table that would damage or
cut the cord. Arrange the cord with care so that it will not be tripped over.
• Inspect control equipment for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip. Immediately report any problems to
Daktronics; save all packing materials if exchange is necessary.
• Keep equipment covered when possible to protect from dust and debris.
1.1

Resources

Figure 1 illustrates a Daktronics drawing label. The drawing
number is located in the lower-right corner of a drawing. This
manual refers to drawings by listing the last set of digits and
the letter preceding them. In the example, the drawing would
be referred to as Drawing D-1007804. All references to drawing
numbers, appendices, figures, or other manuals are presented in
bold typeface. Any drawings referenced in a particular section
are listed at the beginning of it as shown below:
Reference Drawing:
System Riser Diagram ................................................................................................. Drawing D-1007804
All drawings referenced in this manual are found in Appendix A.
Daktronics identifies manuals by the DD or ED number located on the cover page. For example, this manual
would be referred to as DD2298630.
Daktronics has a searchable knowledgebase of common questions and troubleshooting tips:
www.daktronics.com/support
Visit the Daktronics Support YouTube channel to learn how to properly operate Sportsound racks:
www.youtube.com/DaktronicsSupport

Introduction

Introduction
Rack (SSR) 200. For additional information regarding
®
figure 1: Drawing Label
Drawing Number
1