Theralux TVS PRO Installation And Operation Manual page 9

1.25hp and 1.75hp TVS VARIABLE 3 SPEED OPERATION
The TVS Pro Variable Speed Pumps has 3 speed settings....
1. Eco (Energy Saving)

This should be used for everyday water filtration

The pump should be operated for approximately 8 hours per day depending on the
surrounding climate, bather loads, pool volume and length of pipework.

In some cases when your pool has areas where water is not turning over, increase the
speed setting

This setting is not recommended to be used with a suction cleaner but may work.
2. Med

This should be used for gentle spa jet action and the majority of suction cleaners when
connected to a skimmer box
3. High

This should be used for backwashing, manual vacuuming of the pool, operating gentle or
soft spa jets and/or water features.
PLEASE NOTE

The TVS Pro will always run at "high" speed for 3 minutes upon start up or a filter
cycle. This assists with priming of the pump and pipe work.

After the initial 3 minutes the TVS Pro will revert back to the previous selected speed
it was set at before it was turned off.

Priming function can be disable, however, this is not recommended
CHANGING PRIME ON/OFF, PRIME DURATION AND PRIME SPEED

Turning Prime On / Off
Press the stop button 3 times simultaneously
o
Screen should read "P off"
o
Do this again to turn it on, "P on"
o
Disabling Prime function is not recommended for standard operation use
o

Changing Prime Duration
Hold Off button for 10sec
o
Screen with display P 3 -- Depicting 3 Minutes
o
 Changing Prime Speed
Hold Off button for 10sec
o
Screen with display P 3 -- Depicting 3 Minutes
o
Change Prime Duration if required (See above)
o
This can be increase up to 120 minutes

 Press set to save 3 times
Press Set -- P 3

Screen will display 2850 (Highest possible speed)

Increase or decrease as desired by using up and down arrows

Press set to save 2 times

Page 9 of 15