Table of Contents
Advertisement
"E
P
. M
" 120 V
SPRESSO
OINT MOD
ATINÈE
Deliver y unit - chamber
maintenance
Unscrew and remove the four screws (A) positioned
in the cup compartment.
By lifting the complete plate it is possible to remove
the chamber.
To dismantle the chamber it is necessary to secure
it to a blocking device, and by a 25 mm socket
spanner, unscrew the blocking nut (20).
Extract the membrane (22).
To reassemble the chamber place the F.A.P.
PRESSER (26) and the spring (24) in its seat paying
particular attention to the spring-end position
shown in the figure.
Lubricate the inside of the new membrane with
vaseline.
Assemble the lower disc (23), the new membrane
(22), the upper disc (21) and the nut (20) with the
grooved side facing upwards.
Tighten completely the nut using the special
equipment.
3.1
4/4
C
. 83312 / R
. 1.00 / F
2003
OD
EL
EBRUARY
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Espresso Point Matinee 120V and is the answer not in the manual?
Questions and answers
heating chamber remains cold
The heating chamber on the LAVAZZA Espresso Point Matinee 120V may be cold due to a faulty electronic card or a damaged thermostat. If the feed pilot light blinks, one or both thermostats may be damaged and need replacement. If all six indicators remain off after the heating period, the electronic card may be defective and should be replaced.
This answer is automatically generated
What are the specs for the small O ring seal positioned between the labyrinth and chamber cover on the Lavazza Espresso Point
The specifications for the small O-ring seal between the labyrinth and the chamber cover on the Lavazza Espresso Point Matinee 120V are not provided in the available information.
This answer is automatically generated