Timecode Setup; Test Mode Setup - Pangolin FB4 SE Manual

2021/05/05 22:11
[Off] Termination is always disabled.
[Profile] Determines which Fixture profile is active.
[FB3] 16 channel DMX/Artnet fixture profile is active
[FB4] 39 channel DMX/Artnet fixture profile is active
[Timeout] The FB4 has an adjustable timeout period for DMX. If no
DMX frames where received within the specified period, output will stop. This value should be adjusted so
that output does not stop too early, when the DMX framerate is low, but still in a timely manner when the
DMX source disappears. (the default value is 3.0)

Timecode Setup

[Time code setup] offers the ability to start a show based on an incoming Artnet timecode signal. The
FB4 will execute the file once the offset time mark has been received. The file that is executed needs to
be prepared through Laser Show Designer QuickShow or BEYOND it's FB4 export utility.
[TC Type] ATC
[File Index] The actual file that will be executed as soon as the offset has been reached.
[Offset Hrs] The hour mark the FB4 should respond on.
[Offset Min] The minute mark the FB4 should respond on.
[Offset Sec] The second the FB4 should respond on.
[Offset mS] The millisecond the FB4 should respond on.

Test mode Setup

Test mode setup lets you test and setup your laser without the need to connect additional
equipment. Once operation mode [test mode] has been enabled, the [test mode setup]
becomes available. Test frames need to be uploaded through Laser Show Designer
QuickShow or BEYOND its FB4 Export Utility.
[Enable laser] Enables laser output
[Test pattern] Determines which test frame will be displayed
[Brightness] Determines the maximum brightness used during display of the test frames
[Master size] Determines the X and Y size of the projection output.
Geo Correction
Geometric correction allows you to apply corrections on the output of the FB4 scannable
regions with the purpose to give you exact control. Master settings take precedence, so
the settings below will be "stacked" on top of the master settings. Geometric corrections
are saved when powering down the FB4. Settings are saved on the SD card.
[X Scale] Adjusts the horizontal size of the output area from 100% to -100%
[Y Scale] Adjusts the vertical size of the output area from 100% to -100%
Complete Help Docs - https://wiki.pangolin.com/
9/21
1)
FB4 SE Manual