Getting Started; Installation - Worx WA0863 Manual

Getting started

INSTALLATION

Before proceeding with the installation please make sure your Landroid's firmware is updated to the last version. For more information on
firmware upgrade please refer to the "Maintenance" section of the Landroid-o-pedia (https://support.worx-europe.com).
Follow the steps below according to the Landroid model you own
Landroid S 300 (WR130E)
Landroid M 500 (WR141E)
1
START
1. Turn off Landroid
3
3. Take out the slot cover using a screwdriver
5
5. Put the cover back and secure it with
the included
OK
SET
screws.
2. Remove Landroid blades using a screwdriver – wear gloves to
avoid injury
4
4. Plug the cables of the Off Limits until you hear a "click" and
insert the module in its slot
6
6. Screw Landroid blades back in and
turn Landroid on.
EN
CLICK!
7