Error Codes - GE Kelman Minitrans Operator's Manual

6.2

Error Codes

The LCD panel error codes are listed in Table 6-1.
Note: Error codes are offset by 1 from the Modbus register bit numbers.
Note: This information relates to firmware version PGA 14.0.81 for Minitrans.
Table 6-1: Error codes
Code Error
PGA Connection Error
Timeout
01 PGA power supply voltage too low
02 PGA chopper frequency outside range
03 PGA IR-source outside range
04 Gas flow lower than limit
05 Background noise/vibration too high
06 Microphone test failed
07 Not level sensor 1 pulses (level)
08 Not level sensor 3 (drain)
09 Fill level shows Oil
10 Over Fill shows Oil
11 PGA Air temperature outside limits
12 Bad communication with control PCB
13 Gas leak test: Pump pressure too low
14 Gas leak test: Pressure decay too high
15 Unusual ambient gas measurements
16 Oil temperature too low
17 Oil temperature too high
18 Oil pressure too low
19 Oil pressure too high
20 Oil pump tacho count too high
21 Oil pump pressure too low
22 Oil pump speed out of range
23 Manual oil sampling switch
24 Oil pump tacho count too low
25 -
26 5 V supply below 4.5 V
27 Temperature Sensor(s) 1
disconnected
28 Temperature Sensor(s) 2
disconnected
29 Drain level shows oil
MA-006- Minitrans Operator Guide - Rev 2.2
Note
Check that all oil supply valves are open.
Check that all oil return valves are open.
Not used.
5-Mar-20 Page 18 of 26