Princeton Tec GENESIS Operating And Maintenance Instructions

GENESIS
LED FLASHLIGHT
Operating and Maintenance
Instructions
Notice d'utilisation et d'entretien
und Wartungsanleitung
www.princetontec.com
ENGLISH
Battery Installation – See Battery
Installation Diagram
Genesis uses two CR123 Lithium
Batteries, as supplied by Princeton Tec.
When not using Genesis, separate the
head and tail by turning counterclockwise
approximately one turn. This will prevent
accidental activation and eliminate any
potential battery drain. Remove batteries
when storing Genesis.
Observe proper battery polarity when
installing the batteries. Improper
installation of the batteries will damage
light and void warranty.
Princeton Tec cares about the
environment and recommends recycling
batteries.
For more information about battery
recycling, please go to:
www.batteryrecycling.com
WARNING
• Genesis is designed primarily for use
under water. While the flashlight can
also be used above water, extended
use should be avoided. Always
take care to avoid overheating and
damaging the flashlight or causing
burns.
• Never mix fresh and used batteries.
• Never mix different battery brands or
chemistry types.
• Always remove drained batteries
immediately.
• Remove batteries during long periods
of storage.
NOTE: Lithium batteries offer
extended constant brightness time, 10
year shelf life, extreme cold weather
performance, and lighter weight than
other battery types.
Genesis has waterproof seals. It is
important to keep these seals free from
dirt and away from harsh chemicals to
preserve waterproof integrity. Inspect
seals every time batteries are changed.
If dirt is present, wipe gently with a
damp cloth and mild soap until dirt is
Figure 1 – Switch Operation
• Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of
0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
• Princeton Tec berechnet die Gesamtbrenndauer bezogen auf eine von der Stirnlampe erzeugte minimale
Beleuchtungsstärke von 0,25 Lux in 2 Meter Abstand. 0,25 Lux entsprechen in etwa der Beleuch-
tungsstärke des Vollmonds in einer klaren Nacht.
• Princeton Tec définit la durée totale d'éclairage comme le temps nécessaire à la source
lumineuse pour produire un minimum de 0,25 lux à 2 mètres. 0,25 lux équivaut à peu près à la
luminosité d'une pleine lune dans un ciel nocturne dégagé.
Figure 2 – Battery Replacement
TM
1
removed. Add silicone lubricant to the
seals if they appear dry or after cleaning.
Do not use petroleum based products to
lubricate seals.
Switch Operation – See operation
diagram
A single press of the recessed switch
activates Genesis, while subsequent
presses cycle through modes and turn
the light off. Genesis has high output, low
output, and SOS modes.
The integrated Power Indicator glows
blue during regular burn time, turning
red with approximately 25% of burn
time remaining.
O-Ring and Lens Cap
Occasionally clean and lightly lubricate
the O-ring and Lens Cap threads. Use
only silicone grease, never use aerosol
spray lubricants. Certain types of aerosol
sprays can cause damage the plastic and
void the warranty.
General Maintenance
As with any outdoor equipment, the light
should be kept clean with mild soap and
water. Avoid getting dirt on the o-ring and
in the threads of the lens cap. If this should
occur, take the light apart, remove the
o- ring, light module and batteries, then
clean the light body, lens and o ring re-lubricate
the o-ring and reassemble the light.
Troubleshooting
If the Genesis fails to light:
• Check the batteries for proper installation.
• Replace batteries if proper installation is
confirmed.
• Check the light for water contamination.
The light will resume normal operation
once the water is shaken or blown out
and the light is left open until completely
dry. If the light has been contaminated
with salt water, flush the unit with fresh
water and dry as described above.
USA– International 1-Year Warranty
WARRANTY – Princeton Tec warrants
this product to be free from defects in
workmanship and materials under normal
Opération de commutation
1 Maxbright LED
DISTANCE (Meters) 1
Remplacement des piles
2
4
Schalterbetätigung
LOW 5H
65 120
Betriebsartenschalter
3
5
use for one year from the original date
of purchase. This warranty covers all
of the component parts of the product
except batteries. This warranty does not
cover deterioration due to normal wear
or damage due to misuse, alteration,
negligence, accidents, or unauthorized
repair. Princeton Tec will repair or replace
parts which are defective in workmanship
or materials. Your authorized Princeton
Tec Dealer and Princeton Tec are the
only facilities authorized to repair the
product. After (3) unsuccessful attempts
(within the warranty period) to repair
the product, you have the right to elect
replacement of the product or a refund
of the purchase price less allowance for
use of the product. NO INCIDENTAL
OR CONSEQUENTIAL DAMAGES
ARE INCLUDED IN THIS WARRANTY.
(Some states do not allow the exclusion
or limitation of incidental or consequential
damages, so the above limitations or
exclusions may not apply to you.) This
warranty gives you specific legal rights,
and you may also have other rights which
vary from state to state.
Princeton Tec reserves the right to
change product specifications without
notice.
Return Policy
If your light fails to operate, follow these
simple steps:
1) Check batteries. Replace if necessary.
2) Contact Princeton Tec customer service at
800-257-9080 to request an RMA number to
send your light in for repair or replacement.
No warranty repairs will be accepted without
an RMA number.
3) Return the light without batteries to:
Princeton Tec, 5198 Rt. 130, Bordentown,
NJ 08505. Postage due and freight
collect items will not be accepted.
Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
www.princetontec.com
© 2014 Princeton Tec
HIGH 3H
SOS 24H
255