NEC PA-MR10LN Instruction Manual page 23

Important safety information regarding radio frequency
(RF) exposure and use when worn
The product "MR10LN"is declared to conform with the essential requirements
of the Federal Communications Commission of the U.S. Government.
This wireless portable device complies with the FCC requirements for
exposure to radio waves.
Your wireless portable device is a radio transceiver and receiver. It is designed
not to exceed the SAR*(Specific Absorption Rate) limits** for exposure to
radiofrequency (RF) energy by the FCC Directives.
The Max. SAR* value is 1.55W/kg (1 g) when it is worn on the body. To comply
with the RF Exposure limits.
For body worn operation, this device has been tested and meets the FCC RF
exposure guidelines. During communication, please use an accessory
designated for this product and which positions the device a minimum of
0.5cm from the body.
The use of accessories that do not satisfy these requirements may not comply
with FCC RF exposure requirements, and should be avoided.
* The exposure standard for wireless portable devices employs a unit of measurement
known as the Specific Absorption Rate, or SAR.
** The SAR limit recommended by theFCC is 1.6W/kg averaged over 1g of tissue.
*** Tests for SAR have been conducted using standard operating positions with the
transmitting at its highest certified power level in all tested frequency bands. Although
the SAR is determined at the highest certified power level, the actual SAR level of the
wireless portable device while operating can be well below the maximum value. This is
because the wireless portable device is designed to operate at multiple power levels so
as to use only the power required to reach the network. In general, the closer you are
to a base station antenna, the lower the power output.
Radiation Exposure Statement
The product comply with the FCC portable RF exposure limit set
forth for an uncontrolled environment and are safe for intended
operation as described in this manual. The further RF exposure
reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power
if such function is available.
23