Sealey TP696 Instructions

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear Protective
instruction Gloves
manual
1. SafetY
Keep the extractor clean and maintain it in good condition (use an authorised service agent).
9
replace or repair damaged parts. use genuine parts only. unauthorised parts may be dangerous
9
and will invalidate the warranty.
9
Keep all non-essential persons away from the work area.
9
check extractor connections and fittings before use.
9
ensure that the tank capacity exceeds the amount of fluid to be collected.
9
do Not use the extractor for any purpose other than that for which it is designed.
8
do Not operate the extractor if any parts are damaged or missing as this may cause failure
8
and/or personal injury.
do Not leave the extractor operating unattended.
8
WarNiNG! engine oil will be hot when extracting.
‰
imPortaNt! ensure that you wear protective clothing, gloves, goggles, face mask as appropriate
‰
for the fluid being extracted.
WarNiNG! do Not allow uncontrolled discharge of fluids thus polluting the environment.
‰
do Not use the unit to extract dangerous chemicals, poisons, acids, alkalines or solvents.
8
the container is not designed for long term storage.
8
do Not store the unit under extreme conditions.
8
do Not turn the container upside-down when it is holding fluids.
8
do Not adapt the unit for any other purpose.
8
1.1. dispose of waste fluids in accordance with local authority regulations.
WarNiNG! do Not use with gasoline or other flammable liquids.
‰
1.2. When not in use, disconnect from the air supply and store in a safe, dry, childproof area.
2. iNtroductioN
i
5.5ltr capacity device constructed from composite materials and suitable for the extraction of engine oils from cars, motorcycles,
marine engines, stationary engines and industrial machinery. Suitable also for low viscosity fluids such as water. Supplied
with 2100mm suction probe, easy-pour spout and cover cap. use suction probe to remove engine oil through the dipstick tube.
3. SPecificatioN
i
capacity. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.5 litre
overall length of suction probe . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2100mm
4. aSSemblY
Note: the black section of the probe is permanently joined to the clear section and cannot be separated.
4.1. screw handle (f) onto pump shaft (B).
4.2. Replace red cap on container (G) with tube cap (D) and fix firmly.
4.3. Before attaching pump (B), make sure the black rubber collar (e) on container(A) is firmly seated.
© Jack sealey limited
instructions for
vacuum oil/fluid extractor 5.5 ltr
model no:
Wear eye Wear Protective
Protection
clothing
Original Language Version
tP696
fig.1
tP696 issue 2 (H, f) 11/01/18