Setup With Studiox; Receiver Type - Beastx MICROBEAST PLUS Manual

26 Setup with StudioX

When StudioX is started and your MICROBEAST PLUS was detected by StudioX, click
the Control Setup tab to show the adjustment options of RECEIVER MENU. The options
you see here are basically similar to the Menu Points you can change directly at the device.
At the top of the screen you can see which type of input signal is selected at the moment.
The rows below show what channels are assigned to which control functions. Finally, in the
last row you can see the internal value for throttle failsafe position that is set at the moment.
Choose Control setup
Here you can see current receiver system, function assignment and failsafe setting

26.1 Receiver type

In order to detect the connected receiver type make sure the receiver is bound to the
transmitter and sending out signals. Also make sure the transmitter is setup correctly as
1
shown in the chapter Radio System . Press the "Scan" button to start automatic receiver
detection routine. The Status-LED on the device and the display will indicate which type
the system is scanning for at the moment. When a valid input signal was detected the
receiver type will be set automatically and a dialog will appear in case a single-line receiver
is used. This asks how to proceed with function assignments. When a Standard receiver is
used the system will restart directly and you can leave the setup screen as there . When
detection fails once again make sure your receiver is connected properly to MICROBEAST
PLUS, bound to the transmitter and sending out control signals and try again.
Click scan button...
...and wait until scan is finished
If scan was successful the dialog will show up
1
https://wiki.beastx.com/./index.php/Manuals:MBPlusFblV52:Radio_System/en
61