Connecting To Computer - Canon LV-7345 Owner's Manual

CONNECTING PROJECTOR
Cables used for connection
• VGA Cable (HDB 15 pin)
• Control Cable for PS/2 Port
• DVI-Digital Cable (for Single Link T.M.D.S.)
• Control Cable for Serial Port , or ADB Port
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
RGB IN ANALOG
NOTE :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet.
peripheral equipment on before the
computer is switched on.
MAC ADAPTER (Not supplied)
Set switches as shown in the table
below depending on RESOLU-
TION MODE that you want to use
before you turn on projector and
computer.
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
21" MODE (1152 x 870)
12

CONNECTING TO COMPUTER

( = Cable or adapter is not supplied with this projector.)
Monitor Output Monitor Output
MAC Adapter
Set slide switches
according to the
chart below.
DVI
Cable
VGA Cable
RGB IN DIGITAL
RGB IN AUDIO
DIGITAL R IN
S – VIDEO IN
MCI
Turn the projector and
ON
ON
1
OFF
1 2 3 4
ON ON OFF OFF OFF OFF
OFF ON OFF ON OFF OFF
OFF ON ON OFF OFF OFF
ON ON ON ON OFF OFF
• USB Cable
• MAC Adapter (When connecting to Macintosh computer)
• Audio Cables (RCA x 2 and Mini Plug (stereo) x 1)
Desktop type
Audio Output USB port
Audio USB
Cable Cable
(stereo)
COMPUTER AUDIO IN USB
VIDEO IN
L Y Pb/Cb Pr/Cr
AUDIO
COMPUTER
R L
OUT
AUDIO IN
RESET
RGB IN ANALOG CONTROL PORT
AUDIO OUT
Audio Input
DIP
2 3 4 5 6
External Audio Equipment
5 6
Audio Amplifier
Laptop type
Serial port PS/2 port ADB port
Control Cable Control Cable
Control Cable
for Serial Port for ADB Port
for PS/2 Port
Terminal Terminal Terminal
Use one of these Control
Cables or USB Cable
corresponding with the
terminal of your computer.
CONTROL PORT
Terminals
of the Projector
Audio Cable
(stereo)
Audio Speaker
(stereo)