Sealey DF910.V2 Instructions

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instruction protection
manual
1. safetY
Wear approved safety goggles and protective gloves when operating the folder. Your local sealey stockist offers a complete range of
9
safety equipment.
use the tool only for its intended purpose.
9
check regularly for damaged parts. do not use if any components are broken, worn or damaged.
9
use original sealey spare parts and accessories. use of non-recommended spare parts may be dangerous and will invalidate
9
warranty.
do not operate this tool while under the influence of drugs, alcohol or other impairing medication.
8
do not allow unqualified persons to operate the metal folder. Keep children away from the tool.
8
2. introduction
floor standing metal folder with 910mm capacity. manually operated and suitable for folding up to 0.8mm sheet.
3. specification
model no: ............................................................... df910.V2
maximum sheet size: ................................................. 910mm
maximum sheet thickness: .......................................... 0.8mm
maximum diameter of steel rod: ..................................... 2mm
maximum width of 2mm strip or 2mm diameter steel rod:
................................................................................... 100mm
note: when bending 2mm strip or 2mm diameter steel rod, they must be placed close to one of the set screws.
Weight: ........................................................................... 28kg
4. contents
unpack the unit and check that all parts are included and not damaged. should you experience a problem contact your supplier immediately.
contents: 1x main frame. 2 x cross bars. 1 x folding plate. 1 x foot stand. 1 x Bag of nuts/Bolts consisting of: 2 x set screws (l-shaped),
6 x Bolts, 6 x nuts, 6 x Washers.
© Jack sealey limited
instructions for
floor standing metal folder
model no:
Wear
protective
gloves
Original Language Version
df910.V2
df910.V2| issue:2 (l) 25/10/17