Avery Weigh-Tronix E1010 Service Manual page 26

Service Menu—APP submenu (continued)
(Remote Display)
Disable the sleep timer to
prevent the remote display
from shutting down.
Using an E1010 as
a Remote Display
The E1010 in remote display
mode is compatible with these
indicator strings; WI-125's
default print string, the standard
WI-127's print Layout 5, and the
WI-127 Inbound/Outbound print
Layout 1.
26
1. Press the UNITS key...
R-DISP
R-DISP is displayed.
2. Press the PRINT key...
ON or OFF is displayed.
3. Toggle between the choices by using the UNITS key or TARE key and
press the ENTER key to accept the displayed choice...
R-DISP is displayed.
4. Repeatedly press the SELECT key until APP is displayed.
This completes the APP menu but see below for more information on using
the E1010 as a remote display.
"
To use an E1010 as a remote display the following configurations need to be
set.
1. The host device needs to be configured to broadcast out a continuous
stream of data from its communication port.
2. The host device needs to broadcast a serial data string that is configured
as follows:
<G or N><1 space><weight data><1 space><UU><1 CR><1LF>
The G stands for Gross values and N stand for Net values.
Weight Data that includes polarity and decimal point and 6 digits of
weight data.
The UU is the units of measure in a 2 character format such as lb for
pound or kg for kilograms.
3. The host device and the Remote device need to have the serial communi-
cations setting (I.E. Baud, parity, data bits, and stop bits) matched
between them with no handshaking.
4. The serial cable needs to be matched between the host and the remote.
The E1005 pin outs on the external nine pin D-type serial connector are;
Pin 2 is Transmit
Pin 3 is Receive
Pin 5 is Ground
If you have an existing WI-125RD you can replace it directly with an
E1010. To replace the WI-125 RD make the following changes in the
remote device and properly connect the serial cable.
1. Turn on the E1010 remote display.
2. Configure the serial settings (baud, parity, data bits, and stop bits) to
match the Host device. Hand shaking should be disabled.
3. Make sure the serial cable is wired correctly.
Model E1010 Indicator Service Manual