Advertisement
4.1.5.
Position the extractor unit close to the front or side of the
vehicle. Press fit the 10mm diameter suction tube adaptor to
the inlet coupling (fig.1).
WarninG! Ensure oil temperature does not exceed 70°C.
‰
4.2.
draWinG FLuid intO tHE ExtractOr
nOtE: Before operating the extractor you must press the
pressure release valve (fig.1) to dissipate any vacuum or
pressure remaining in the tank from previous use.
4.2.1.
To commence suction, place your foot over the foot rest to
steady the unit and start to pump the handle up and down
through its full travel. As you pump up and down, the tank
will begin to fill. Stop pumping and press release valve to
prevent the unit overfilling.
4.3.
EMptyinG tHE ExtractOr
nOtE: Before emptying the extractor you must press the
pressure release valve (fig.1) to dissipate any vacuum or
pressure remaining in the tank.
4.3.1.
Carefully remove the suction probe from the dipstick tube using rag or tissue to prevent any oil drips soiling the engine bay. Replace
the dipstick.
4.3.2.
Disconnect the suction tube and the inlet coupling from the extractor body (fig.1).
4.3.3.
empty the extracted fluid into a suitable container. The fluid should be disposed of according to local authority regulations.
dO nOt tilt beyond 90
8
5. MaintEnancE
5.1.
Keep the unit clean, wipe off any fluid spillage. Keep the suction tubes clean and clear of blockages. Check that all tubes, hoses and
connections are in good condition.
Parts support is available for these products. Please email sales@sealey.co.uk or telephone 01284 757500
EnVirOnMEnt prOtEctiOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business park, Bury St Edmunds, Suffolk. ip32 7ar
01284 757500
© Jack Sealey limited
0.
01284 703534
Original Language Version
fig.1
sales@sealey.co.uk
www.sealey.co.uk
S01167 Issue 1 25/10/19
Advertisement
