Page 1
System Firmware Update Instructions for Pioneer In-Dash AV Receivers (DMH-ZS9350BT) This firmware update applies only to the following models of Pioneer In-Dash AV Receivers sold in the Singapore, Malaysia, Indonesia, Philippines, Sri Lanka, Vietnam, Thailand, Cambodia, Myanmar and Laos. DMH-ZS9350BT...
Checking the firmware version Check whether the firmware of your unit needs to be updated by checking the version number of the firmware. Procedure: Touch the following key. The “System” screen appears. Scroll down the list and touch [System Information]. Touch [Firmware information].
Page 3
After the “Firmware Information” screen appears, Check the firmware version number and model name.
Page 4
IMPORTANT DMH-ZS9350BT • DO NOT perform this firmware update if the model number of your Pioneer product is anything other than one of the above models. • Ensure that the update file is located within the root (top) folder of your USB storage device. There should be no other files within the USB storage device.
Page 5
Procedure: 1. Connect a blank (formatted) USB storage device to your computer, and then locate the correct update file and copy it onto the USB storage device. 2. Connect the USB storage device to the USB port. 3. Set the audio source to “OFF” on your unit. 4.
Page 6
7. Touch [USB]. 8. Touch [Continue] to display the data transfer mode. It will take a while to load, so please wait.
Page 7
Read the “WARNING,” then touch the [Start] button to start the update process. If it shows “ERROR” on the display, try another USB device. Version up will start. 10. The progress is displayed during the updating. DO NOT turn your unit off or eject the USB storage device while the firmware is being updated.
Page 8
The product will reboot after the update is finished. Do not touch anything even when the screen is blacked out. After it has finished rebooting, the screen will return to the menu screen. The firmware update is now complete. Your Pioneer AV Receiver is now ready for use.
Page 9
Confirm that the firmware has been updated Perform the same procedure for “Displaying the firmware version” to confirm that the firmware has been updated. Procedure: Touch the following key. The “System” screen appears. Scroll down the list and touch [System Information]. Touch [Firmware information].
Page 10
After the “Firmware Information” screen appears, Check the firmware version number and model name. If you have any difficulty performing these instructions, please contact the nearest Pioneer Customer Service at your country. You can refer to www.pioneer.com.sg/sg/support/service/index.html for more information.