Operation And Installation - Wet Sounds RECON Series Owner's Manual

3

OPERATION and INSTALLATION

Please review the hole cut out dimensions for RECON 6
and RECON 8 speakers and make sure that the correct
and appropriate opening is provided for the speakers.
Be sure to use the stainless steel screws that are
provided. This will prevent against corrosion. Also
included is a waterproof two conductor connector to
connect the speakers to the amplifier or source unit.
The red wire is positive, while the black wire is negative.
*If Equipped with RGB LIGHTNING:
Special instructions about the RGB LED lighting behind the tweeter:
1. The RGB LED 4 wire harness should be connected
with BLACK on +12V (a 2A inline fuse is required to be
added). The other 3 wires (RED, BLUE & GREEN)
can be combined & connected to ground
(-12V in a variety of combinations to achieve one
color of illumination behind the tweeter cup.
For instance – grounding RED & BLUE together will
result in purple color.
2. Adding an LED controller like the Wet Sounds
RF-RGB-MC V2 enables the display of thousands of
color combinations, as well as light changing modes
and the ability to change the lights with music – all
controllable via a hand held wireless remote.
Wet Sounds RECON 6 Coaxial Speaker System. Operations / Installation Manual