Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using
tools and equipment.
DO NOT use the dial bore gauge if damaged.
8
DO NOT drop.
8
This is a precision instrument, always return gauge components to the internally lined storage case.
9
Maintain the gauge in good and clean condition for best and safest performance.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Ensure the work area floor is not slippery; wear non slip shoes.
9
Components to be measured and the dial bore gauge to be stored at room temperature (21°C).
9
2. INTRODUCTION
Precision mechanism with Ø55mm dial and locking rotating bezel, offering an accurate method of measuring a bore or detecting a taper or
ovality. Will indicate the deviation from set size by up to 3mm with an accuracy of 0.01mm. Probe body, dial indicator, anvils and spacer rings
are also included. Supplied in wooden storage case.
3. SPECIFICATION
Dial Diameter: .............................................................. 55mm
Maximum Deviation Measurement with Stem: ............... 1mm
Maximum Deviation Measurement, Gauge: ................... 3mm
Range: .................................................................. 50-160mm
4. CONTENTS
Item .................................................................. Description
1 ..............................................................Dial gauge indicator
2 ...........................................................................Probe body
3 ........................................................................ Clamp screw
4 ........................................................ Distance piece (55mm)
5 ........................................................ Anvils and spacer rings
© Jack Sealey Limited
50-160MM DIAL BORE GAUGE
DBG5010.V2
MODEL NO:
Original Language Version
DBG5010.V2 Issue 1 21/05/20