Advertisement
4.1.
Referring to fig.1
Item ........................................................... Description
1................................................................... Grip Knobs
2............................................................. lifting Handles
3............................................................. Centre Clamps
5..............................................................................Feet
6..........................................................Adjustable Screw
7................................................................. Cross Beam
8................................................................... Main Beam
5. OPERATION
5.1.
The fully assembled support beam is heavy and should be lifted into place by two people.
5.2.
loosen the grip knobs (fig1.1) to allow the assemblies to slide and then locate the rubber feet into the gutters of the vehicle's front
wing panels or close to the suspension strut towers. The feet can be adjusted to allow the main beam to be installed in a level plane
(fig1.5). When located, tighten thoroughly.
Note:
Refer to the manufacturer's handbook to identify engine lifting brackets. If required, loosen the centre clamp (fig1.3) to swivel the cross
beam (fig1.7) to the desired alignment, then re-tighten.
5.3.
drop the adjustable screw assemblies (fig1.6) through the slot in the cross beam in positions adjacent to the engine lifting points. If not
utilising the swivel facility, the lift screw will pass through both the cross beam (fig1.7) and main beam (fig1.8).
5.4.
Attach the hooks to the lifting brackets on the engine and thread grip knobs (fig 1.2) onto adjustable hook assemblies.
5.5.
Progressively rotate the lifting handles (fig1.2) clockwise to support the engine.
5.6.
on completion of the maintenance task, rotate the lifting handles anticlockwise to release the tension on the lifting hook assemblies
5.7.
Unhook, loosen both grips and remove the engine support from the vehicle.
ENvIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
eS601 Issue 2 (HF) 21/08/18
Advertisement
