Wood-mizer LT28 Safety, Setup, Operation & Maintenance Manual page 109

Sawmill Alignment
7
Complete Alignment Procedure
wheel if necessary.
See Figure 7-18. Use the horizontal adjustment screws to adjust the drive-side blade
wheel. To move the blade back on the wheel, loosen the right adjustment screw one quar-
ter turn. Loosen the jam nut on the left adjustment screw and tighten the screw. Tighten
the left and right jam nuts.
To move the blade out on the wheel, loosen the left adjustment screw one quarter turn.
Loosen the jam nut on the right adjustment screw and tighten the screw. Tighten the left
and right jam nuts.
150075-3B
Adjust horizontal adjustment screws
left to move blade out on wheel;
Adjust screws right to move blade in on wheel
FIG. 7-18
Sawmill Alignment 2804doc030317 7-20