Kodak UC102 Quick Start Manual page 6

1 - Unfasten clip su iciently by rotating the clip lever.
2 - Insert clip to the center of the 3 vents (vent 2 on the
diagram) and stick fixing plate against vent 1 & 3 to avoid
shaking while driving. Refer to image 6.
No Gap between
Fixing Plate and Vent
Vent 1 2 3
3 - If this way of fixing the clip is not possible, stick fixing
plate against vent frame and insert clip to a suitable vent.
4 - Fasten clip lever whilst pushing clip deeper so there is no
gap between fixing plate and vent.
Caution: It is recommended the hot air from the vent is
not directed at the holder by adjusting the angle to
avoid overheating of the wireless charger.
5 - Check if vent clip is fixed firmly and correctly.
VENT CLIP INSTALLATION
Vent Frame
image 6
1
2
3
06
Vent Frame
No Gap