Shutdown - NorthStar 1571107 Owner's Manual

Procedure:
1. Install the high-pressure spray nozzle (always relieve
system pressure first and follow instructions for
attaching a nozzle).
High Pressure Fluid Injection Hazard
High-pressure fluid discharge from leaks (even pin sized)
or ruptured components can pierce skin and inject fluid
into the body. Injection injury can result in blood poisoning
and/or severe tissue damage leading to infection,
gangrene, and possibly amputation.
• Never use a finger or skin to check for leaks.
• Never operate pressure washer with damaged or
missing hoses/parts.
• Never attempt to repair a high-pressure hose or
component-Always replace it with a part that is rated at
or above the pressure rating of this pressure washer.
2. Clear the cleaning area of all persons. Keep children
and pets away.
3. Hold the spray gun firmly with two hands and a sturdy
stance -- Gun kicks back when triggered.
4. Wash from the bottom to the top, using side-to-side
motions. This washes away heavy dirt and allows the
detergent to soak as you work toward the top.
5. Use the width of the spray pattern to wash a wide
path. Overlap spray paths for complete coverage.
6. The nozzle should be 12" to 24" from the work, closer
for tough areas.
7. Small parts should be washed in a basket, so the
pressure does not push them away. Larger,
lightweight parts should be clamped down.
8. The pressure washer is set and locked to the
maximum rated pressure when it leaves the factory.
To reduce the pressure, turn the unloader knob
counterclockwise. To return to maximum pressure turn
knob clockwise.
FOR 1571107
UNLOADER
WARNING
FOR 1571108 & 09
UNLOADER
Fig.1571107-9
Operation
9. If temporarily interrupting spraying, rotate trigger
safety latch downward to the locked position to guard
against accidental trigger release.
Do not attempt to alter the unloader valve's maximum
pressure. Excess pressure could cause serious injury
from escaping high-pressure fluids and/or pump damage.
Any alteration other than turning the adjustment knob will
void your warranty.
When not spraying, use the spray gun safety lock
to prevent accidental high-pressure discharge.
Spray Gun
10. Always turn off the motor and activate spray gun
trigger to relieve system pressure when:
•
the sprayer is unattended, or
•
disconnecting hoses, installing/cleaning
nozzles, or servicing the pump.
Always turn off the motor and relieve system pressure
when finished spraying or when leaving sprayer
unattended. Serious injury could result from unintentional
release of high-pressure spray.
Never disconnect the high-pressure hose from the pump
or spray gun while the system is pressurized. Relieve
pressure by squeezing the spray gun trigger after the
motor is turned OFF.
Stop the motor using the following steps:
1. Turn motor OFF.
2. Unplug the power cord.
3. Turn water supply OFF.
4. Squeeze trigger to relieve system pressure.
5. Remove garden hose.
6. Remove pressure hose.
21
WARNING
Warranty Void
Spray Gun Safety Lock
Safety Lock
WARNING
Injury

Shutdown

WARNING
Injury