Sealey AK4403 Instructions

Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instruction protection
manual
1. safeTy
WarnIng! ensure Health & safety, local authority and general workshop practice regulations are adhered to when using this equipment.
‰
familiarise yourself with the application and the limitations of the grease gun, as well as the potential hazards.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Keep the grease gun clean for best and safest performance.
9
check moving parts alignment on a regular basis.
9
do noT use the grease gun for any purpose other than that it was designed for.
8
do noT operate the grease gun if any parts are damaged or missing, as this may cause failure and/or personal injury.
8
When not in use store in a safe, dry, childproof location.
9
WarnIng! Always wear approved eye protection when operating this gun.
‰
2. InTroducTIon
robust, double arm grease gun with aluminium die-cast head. uses screw type grease cartridges using vacuum suction to ensure full utilization
of grease cartridge as well as eliminating priming issues associated with conventional grease guns. features a protective cap for hose storage
preventing contamination. 1/8" BSPT thread and supplied with adaptor to fit most screw type cartridges on the market, including model numbers:
scs107 & scs108. Zinc plated lever handles with rubber ergonomic grips. fitted with minimal wearing parts to ensure prolonged life and
supplied with 300mm (12") delivery hose and 4-jaw coupler.
3. specIfIcaTIon
Model no: ................................................................. aK4403
delivery pressure: ......................................................7500psi
delivery per stroke: ..................................................... 0.8cm²
4. operaTIon
4.1. remove cap from cartridge and screw into grease gun body, (select grease gun cartridge adaptor as appropriate).
4.2. Work handles to displace air from delivery tube.
© Jack sealey limited
instructions for:
double lever grease gun
aK4403
model no:
Original Language Version AK4403 | issue 1 01/02/16