Sealey MS062 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,
WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH
IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE
THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. General Safety
WARNING! ensure Health & safety, local authority and general workshop practice requirements are adhered to when using

this equipment.
WARNING! Always refer to the motorcycle manufacturer's service instructions, or a proprietary manual to establish the

current procedure for removing motorcycle wheels.
ensure that the motorcycle wheel and hub are in good condition.

use the wheel bearing removal kit in a suitable work area. Keep the area clean and tidy and ensure there is adequate

lighting.
Keep children and unauthorised persons away from the work area.

Keep hands clear of the drift and hammer when using the wheel bearing removal kit.

Wear approriate personal protective equipment when using the wheel bearing removal kit. A full range of PPe is available

from your sealey dealer.
DO NOT use the wheel bearing removal kit for any purpose other than for which it is designed.

DO NOT use the wheel bearing removal kit if any part of it is damaged or missing.

DO NOT allow untrained persons to use the wheel bearing removal kit.

DO NOT attempt to remove a motorcycle wheel bearing when you are tired or under the influence of alcohol, drugs or

intoxicating medication.
When not in use, clean the wheel bearing removal kit and store in a safe, dry, childproof area.

WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and

situations that may occur. It must be understood that common sense and caution are factors which cannot be built
into this product, but must be applied by the operator.
2. INTRODUCTION/CONTENTS
2.1. Introduction
for easy removal of wheel bearings. simply choose the correct size collet for the bearing and hammer one of the
drifts into the allocated slot. covers sizes from 10-25mm so should cover most popular motorcycles and AtVs.
2.2. Contents
IteM no.
1
2
3
4
5
© Jack sealey limited 2012
descrIPtIon
large drift
small drift
10mm collet
12mm collet
15mm collet
InstructIons for:
MOTORCYCLE WHEEL BEARING
REMOVAL KIT 9pc
Model no:
IteM no.
6
7
8
9
Original Language Version
MS062
descrIPtIon
17mm collet
19mm collet
20mm collet
25mm collet
Ms062 Issue: 1 - 26/06/12